Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER PUMP (for RHD) › from 2020.11
RM37A0E _54 Brake _086869 BRAKE SYSTEM (OTHER) _0449419 BRAKE BOOSTER PUMP(for RHD) A

BRAKE SYSTEM (OTHER)  BRAKE BOOSTER PUMP(for RHD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during brake booster with accumulator pump assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: Learning can also be performed using the GTS.

Click here(Click here)

Auxiliary battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Control System (Click here)
Parking Support Brake System*
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)
Replacement of brake booster with accumulator pump assembly
1.

Bleed air

2.

Perform "Calibration"


·

DTCs are stored

·

ABS warning light illuminates

·

Brake system warning light (yellow indicator) illuminates

·

Slip indicator light illuminates

·

VSC disabled or malfunctions


(Click here)

NOTICE:
·

After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.

·

While the auxiliary battery is connected, even if the ignition switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.

·
C447708C01
1.135,1.448 0.979,1.24 false 2.292,0.417 2.479,0.271 false 2.177,0.906 2.479,1.031 false 2.094,1.958 2.5,1.958 false 0.813,1.146 1.125,1.302 0.313,0.156 10 false *a 2.521,0.167 2.833,0.323 0.313,0.156 10 false *b 2.521,0.958 2.833,1.115 0.313,0.156 10 false *c 2.552,1.885 2.865,2.042 0.313,0.156 10 false *d
*a Union
*b Connector
*c Wire Harness
*d Stud


Do not carry the brake booster with accumulator pump assembly by the parts shown in the illustration.



PROCEDURE

Hide 1.REMOVE BRAKE ACTUATOR WITH BRAKE BOOSTER PUMP ASSEMBLY

Hide 47070B 2.REMOVE BRAKE BOOSTER WITH ACCUMULATOR PUMP ASSEMBLY

a.
C447706

Disengage the 2 clamps to separate the wire harness from the brake actuator with bracket.


b.
C447707

Remove the nut, brake booster with accumulator pump assembly, brake traction actuator bracket bushing and No. 1 brake actuator case collar from the brake actuator with bracket.

NOTICE:

Do not carry the brake booster with accumulator pump assembly by the parts shown in the illustration.



Hide 47381 3.REMOVE NO. 1 BRAKE TUBE CLAMP BRACKET

a.
C448522

Remove the bolt and No. 1 brake tube clamp bracket from the brake booster with accumulator pump assembly.