Home › Drivetrain › P810 (HYBRID TRANSMISSION / TRANSAXLE) › SHIFT PADDLE SWITCH › from 2020.11
RM37A0E _52 Drivetrain _086860 P810 HYBRID TRANSMISSION / TRANSAXLE _0449554 SHIFT PADDLE SWITCH A

P810 HYBRID TRANSMISSION / TRANSAXLE  SHIFT PADDLE SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during shift paddle switch (transmission shift switch assembly) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: Learning can also be performed using the GTS.

Click here(Click here)

Auxiliary battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Control System (Click here)
Parking Support Brake System*1
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)

NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


PROCEDURE

Hide 1.REMOVE STEERING WHEEL ASSEMBLY

Hide 84250A 2.REMOVE STEERING PAD SWITCH ASSEMBLY

Hide 3.REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)

a.
C450246

Remove the 2 screws and disengage the 2 guides to disconnect the 2 shift paddle switches (transmission shift switch assemblies) from the steering wheel assembly.


b.
C450247

Disengage the 4 claws.


c.
C450248

Disengage the 4 guides to remove the 2 shift paddle switches (transmission shift switch assemblies) with No. 1 switch wire from the steering wheel assembly.


d.
C452145C01
0.708,0.75 0.708,0.375 0.708,0.375 0.542,0.375 false 2.667,0.74 2.667,0.365 2.667,0.365 2.833,0.365 false 0.365,0.292 0.667,0.51 0.302,0.219 10 false *1 2.875,0.271 3.146,0.542 0.271,0.271 10 false *2
*1 No. 1 Transmission Shift Switch Assembly
*2 No. 2 Transmission Shift Switch Assembly


Disconnect the No. 1 transmission shift switch assembly connector and No. 2 transmission shift switch assembly connector to remove the No. 1 transmission shift switch assembly and No. 2 transmission shift switch assembly from the No. 1 switch wire.