Home › Drivetrain › UA80E (AUTOMATIC TRANSMISSION / TRANSAXLE) › SPEED SENSOR › from 2020.11
RM37A0E _52 Drivetrain _094409 UA80E AUTOMATIC TRANSMISSION / TRANSAXLE _0449677 SPEED SENSOR A

UA80E AUTOMATIC TRANSMISSION / TRANSAXLE  SPEED SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission revolution sensor (NT) and transmission revolution sensor (NC) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: Learning can also be performed using the GTS.

Click here(Click here)

Battery terminal is disconnected/reconnected Idle the engine for approximately 5 to 60 minutes or drive the vehicle until stop and start control is permitted Stop and Start System (Click here)
Perform steering sensor zero point calibration Lane Control System (Click here)
Parking Support Brake System*1
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)
Replacement of transmission valve body assembly
·

Perform reset memory

·

Reset transaxle compensation code

·

Perform road test to allow ECM to learn


·

Large shift shock

·

Deterioration of fuel efficiency


for Initialization:
(Click here)
for Registration:
(Click here)
Replacement of automatic transaxle fluid ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly (Click here)

NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


PROCEDURE

Hide 35410 1.REMOVE TRANSMISSION VALVE BODY ASSEMBLY

Hide 89413N 2.REMOVE TRANSMISSION REVOLUTION SENSOR (NT)

a.
C361014

Remove the bolt and transmission revolution sensor (NT) from the automatic transaxle case sub-assembly.


Hide 89413S 3.REMOVE TRANSMISSION REVOLUTION SENSOR (NC)

a.
C361013

Remove the bolt and transmission revolution sensor (NC) from the counter drive gear sub-assembly.