Home › Drivetrain › UA80E (AUTOMATIC TRANSMISSION / TRANSAXLE) › VALVE BODY ASSEMBLY › from 2020.11
RM37A0E _52 Drivetrain _094409 UA80E AUTOMATIC TRANSMISSION / TRANSAXLE _0449679 VALVE BODY ASSEMBLY A

UA80E AUTOMATIC TRANSMISSION / TRANSAXLE  VALVE BODY ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission valve body assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: Learning can also be performed using the GTS.

Click here(Click here)

Battery terminal is disconnected/reconnected Idle the engine for approximately 5 to 60 minutes or drive the vehicle until stop and start control is permitted Stop and Start System (Click here)
Perform steering sensor zero point calibration Lane Control System (Click here)
Parking Support Brake System*1
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)
·

Replacement of transmission valve body assembly

·

Replacement of solenoid (SL1, SL2, SL3, SL4, SL5 and/or SL6) valve


·

Perform reset memory

·

Reset transaxle compensation code

·

Perform road test to allow ECM to learn


·

Large shift shock

·

Deterioration of fuel efficiency


for Initialization:
(Click here)
for Registration:
(Click here)
Replacement of automatic transaxle fluid ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly (Click here)

NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


PROCEDURE

Hide 35410 2.REMOVE TRANSMISSION VALVE BODY ASSEMBLY

a.
C361011

Disengage the clamp to disconnect the transmission revolution sensor (NC) wire connector.


b.
C365886

Remove the 9 bolts and transmission valve body assembly from the automatic transaxle case sub-assembly.


c.
C365887C01
2.385,1.969 2.75,2.177 0.365,0.208 10 false *1 0.958,1.969 1.167,2.167 0.208,0.198 10 true *2 0.823,1.5 1.052,1.688 0.229,0.188 10 true *3 2.438,1.625 2.802,1.833 0.365,0.208 10 true *1 1.781,0.229 2,0.417 0.219,0.188 10 true *1 0.948,1 1.167,1.188 0.219,0.188 10 true *1
*1 Transaxle Case Gasket
*2 No. 1 Front Oil Pump Cover Gasket
*3 No. 2 Front Oil Pump Cover Gasket


Remove the 2 transaxle case gaskets from the automatic transaxle case sub-assembly.


d.

Remove the transaxle case gasket from the counter drive gear sub-assembly.


e.

Remove the transaxle case gasket from the front oil pump assembly.


f.

Remove the No. 1 front oil pump cover gasket from the front oil pump assembly.


g.

Remove the No. 2 front oil pump cover gasket from the front oil pump assembly.