The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during No. 1 cooler thermistor removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
87130D
1.REMOVE BLOWER ASSEMBLY
82210K
2.REMOVE AIR CONDITIONING HARNESS ASSEMBLY
87050C
3.REMOVE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (for Single Type)
87050C
4.REMOVE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (for Dual Type)
87128
5.REMOVE HEATER GROMMET
87124B
6.REMOVE HEATER CLAMP
87107A
7.REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY
88899L
8.REMOVE COOLING UNIT PARTS
9.REMOVE COOLER EXPANSION VALVE
88501
10.REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
88625
11.REMOVE NO. 1 COOLER THERMISTOR
w/o Stop And Start System:
Remove the No. 1 cooler thermistor.
w/ Stop And Start System:
Remove the No. 1 cooler thermistor.