48818
1.INSTALL REAR STABILIZER BUSHING
| *a | Stopper |
Install the 2 rear stabilizer bushings to the inside of the stoppers on the rear stabilizer bar.
Be sure to install the rear stabilizer bushings so that each cutout faces the front of the vehicle.
48824R
2.INSTALL REAR STABILIZER BRACKET
| *a | Arrow Mark |
| *b | Identification Mark |
|
Upper Side of the Vehicle |
Install the 2 rear stabilizer brackets to the 2 rear stabilizer bushings.
Be sure to install the rear stabilizer brackets so that each arrow mark faces the upper side of the vehicle.
Ensure that the identification mark faces the right side of the vehicle.
48835
3.INSTALL REAR LOWER STABILIZER BRACKET
| *a | Arrow Mark |
|
Upper Side of the Vehicle |
Install the 2 rear lower stabilizer brackets to the rear suspension member sub-assembly.
Be sure to install the rear lower stabilizer brackets so that each arrow mark faces the upper side of the vehicle.
48812
4.INSTALL REAR STABILIZER BAR
| *a | Identification Mark |
Install the rear stabilizer bar, 2 rear stabilizer brackets and 2 rear stabilizer bushings to the rear suspension member sub-assembly with the 4 nuts.
Ensure that the identification mark faces the right side of the vehicle.
5.TEMPORARILY INSTALL REAR STABILIZER LINK ASSEMBLY LH
Temporarily install the rear stabilizer link assembly LH to the rear stabilizer bar with the nut (B).
Temporarily install the rear stabilizer link assembly to the rear No. 2 suspension arm assembly with the bolt and nut (A).
Because the nut (A) has its own stopper, do not turn the nut (A). Tighten the bolt with the nut (A) secured.
Insert the bolt with the threaded end facing the front of the vehicle.
6.TEMPORARILY INSTALL REAR STABILIZER LINK ASSEMBLY RH
Perform the same procedure as for the LH side.
7.STABILIZE SUSPENSION
8.INSTALL REAR STABILIZER LINK ASSEMBLY LH
Install the rear stabilizer link assembly LH to the rear stabilizer bar with the nut (B).
If the ball joint turns together with the nut (B), use a 6 mm hexagon socket wrench to hold the stud bolt.
Install the rear stabilizer link assembly to the rear No. 2 suspension arm assembly with the bolt and nut (A).
Because the nut (A) has its own stopper, do not turn the nut (A). Tighten the bolt with the nut (A) secured.
w/ Cap:
Install the cap to the rear stabilizer link assembly LH.
9.INSTALL REAR STABILIZER LINK ASSEMBLY RH
Perform the same procedure as for the LH side.
48738
10.INSTALL REAR SUSPENSION ARM COVER LH
48737
11.INSTALL REAR SUSPENSION ARM COVER RH
Perform the same procedure as for the LH side.
12.INSTALL REAR WHEEL