Home › Engine / Hybrid System › STOP AND START › ENGINE STOP AND START SOLENOID FILTER › from 2020.11
RM37A0E _51 Engine / Hybrid System _094408 STOP AND START _0452244 ENGINE STOP AND START SOLENOID FILTER A

STOP AND START  ENGINE STOP AND START SOLENOID FILTER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine stop and start solenoid filter removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: Learning can also be performed using the GTS.

Click here(Click here)

Battery terminal is disconnected/reconnected Idle the engine for approximately 5 to 60 minutes or drive the vehicle until stop and start control is permitted Stop and Start System (Click here)
Perform steering sensor zero point calibration Lane Control System (Click here)
Parking Support Brake System*1
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)
Replacement of Engine stop and start ECU
·

Upload the number of starter operations

·

Perform external backup boost converter (eco run vehicle converter assembly) existence learning

·

Reset air conditioning information

·

Learning air conditioning information

·

Clear the zero point calibration data

·

Perform zero point calibration of the deceleration sensor


Stop and Start System (Click here)

NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


PROCEDURE

Hide 89261A 1.REMOVE ENGINE STOP AND START ECU

Hide 8926A 2.REMOVE ENGINE STOP AND START SOLENOID FILTER

a.
A480203

Remove the nut and engine stop and start solenoid filter from the engine stop and start ECU.