Home › Vehicle Interior › SEAT › POWER SEAT SWITCH › 2020.11–2021.10
RM37A0E _58 Vehicle Interior _086894 SEAT _0416492 POWER SEAT SWITCH A

SEAT  POWER SEAT SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front power seat switch removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced (for HV Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: Learning can also be performed using the GTS.

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane Control System (Click here)
Parking Support Brake System*1
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)

Necessary Procedures After Parts Removed/Installed/Replaced (for Gasoline Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: Learning can also be performed using the GTS.

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Idle the engine for approximately 5 to 60 minutes or drive the vehicle until stop and start control is permitted Stop and Start System (Click here)
Perform steering sensor zero point calibration Lane Control System (Click here)
Parking Support Brake System*1
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)

CAUTION:
B543257

Wear protective gloves. Sharp areas on the parts may injure your hands.


NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The following procedure is for LHD vehicles.

·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.


Hide 71074S 3.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

Hide 71868N 4.REMOVE FRONT SEAT FRONT CUSHION SHIELD

Hide 71812D 5.REMOVE FRONT SEAT CUSHION SHIELD (for Driver Side)

Hide 71811D 6.REMOVE FRONT SEAT CUSHION SHIELD (for Front Passenger Side)

Hide 84921B 7.REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

Hide 84921A 8.REMOVE RECLINING POWER SEAT SWITCH KNOB

Hide 72714 9.REMOVE SEAT ADJUSTER SHIELD CLAMP BRACKET (for Driver Side)

Hide 84922C 10.REMOVE FRONT POWER SEAT SWITCH

a.

for Driver Side:

i.
B564939

Remove the 2 screws and front power seat switch from the front seat cushion shield.



b.

for Front Passenger Side:

i.
B564938

Remove the 3 screws and front power seat switch from the front seat cushion shield.