The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front seatback heater assembly removal/installation are shown below.
Wear protective gloves. Sharp areas on the parts may injure your hands.
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
Use the same procedure for RHD and LHD vehicles.
The following procedure is for LHD vehicles.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
2.REMOVE FRONT SEAT ASSEMBLY
71074S
3.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER
71868N
4.REMOVE FRONT SEAT FRONT CUSHION SHIELD
71812D
5.REMOVE FRONT SEAT CUSHION SHIELD (for Driver Side)
71811D
6.REMOVE FRONT SEAT CUSHION SHIELD (for Front Passenger Side)
71862
7.REMOVE FRONT SEAT INNER CUSHION SHIELD (for Driver Side)
71861
8.REMOVE FRONT SEAT INNER CUSHION SHIELD (for Front Passenger Side)
9.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
71930A
10.REMOVE FRONT SEAT HEADREST SUPPORT ASSEMBLY
11.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
71074S
12.REMOVE SEPARATE TYPE FRONT SEATBACK COVER
87510N
13.REMOVE FRONT SEATBACK HEATER ASSEMBLY
Remove the 24 tag pins and front seatback heater assembly from the separate type front seatback cover.