1.INSTALL REAR BUMPER ASSEMBLY
Connect each connector.
Engage the 2 clips and 2 claws.
Engage the 16 claws.
Install the 2 screws.
Install the 5 clips.
Install the rear bumper assembly with each screw.
Remove the protective tape.
81498
2.INSTALL REAR COMBINATION LIGHT COVER LH
81497
3.INSTALL REAR COMBINATION LIGHT COVER RH
Use the same procedure as for the LH side.
75874
4.CONNECT QUARTER PANEL WHEEL OPENING MOULDING LH
Install 3 new clips to the quarter panel wheel opening moulding LH.
Engage the 3 clips.
|
Install in this Direction |
Engage the 3 claws as shown in the illustration.
Connect the quarter panel wheel opening moulding LH with the screw and 3 clips.
Remove the protective tape.
75873
5.CONNECT QUARTER PANEL WHEEL OPENING MOULDING RH
Use the same procedure as for the LH side.
76626D
6.INSTALL REAR QUARTER PANEL MUDGUARD LH
76625D
7.INSTALL REAR QUARTER PANEL MUDGUARD RH
Use the same procedure as for the LH side.
8.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL (w/ Kick Sensor)
for 2GR-FKS:
Click hereGeneral>MAINTENANCE>2GR-FKS BATTERY>INSTALLATION
for A25A-FXS, A25B-FXS:
Click hereGeneral>MAINTENANCE>A25A-FXS, A25B-FXS AUXILIARY BATTERY>INSTALLATION
58441L
9.INSTALL BATTERY SERVICE HOLE COVER (w/ Kick Sensor)
for HV Model:
Click hereGeneral>MAINTENANCE>A25A-FXS, A25B-FXS AUXILIARY BATTERY>INSTALLATION
891B2
10.INSPECT KICK DOOR CONTROL SENSOR (w/ Kick Sensor)
11.PERFORM CALIBRATION (w/ Parking Support Brake System)