Home › Power Source / Network › NETWORKING › NETWORK GATEWAY ECU › from 2020.11
RM37A0E _57 Power Source / Network _086883 NETWORKING _0417554 NETWORK GATEWAY ECU A

NETWORKING  NETWORK GATEWAY ECU  REMOVAL  


PROCEDURE

Hide 67913 1.REMOVE FRONT DOOR SCUFF PLATE RH (for LHD)

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL


Hide 62111A 2.REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH (for LHD)

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL


Hide 62311B 3.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH (for LHD)

Hide 55435A 4.REMOVE INSTRUMENT PANEL FINISH END PANEL RH (for LHD)

Hide 55607 5.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)

Hide 55303B 6.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY (for LHD)

Hide 82877 7.REMOVE ECU INTEGRATION BOX RH (for LHD)

a.

Disconnect each connector.


b.
E428226

Disengage the 2 clamps.


c.
E428227C01
0,0 0,0 false
V100135

Nut
V100136

Bolt


Remove the nut, bolt and ECU integration box RH.


Hide 89111 8.REMOVE CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU) (for LHD)

a.
E428228C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 2 claws to remove the central gateway ECU (network gateway ECU) as shown in the illustration.

NOTICE:
·

If the ECU integration box RH is deformed or damaged, replace it.

·

Do not bend the 2 claws more than necessary.




Hide 73900 9.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for RHD)

Hide 55308B 10.REMOVE NO. 3 INSTRUMENT PANEL TO COWL BRACE SUB-ASSEMBLY (for RHD)

a.
E455746C02
0,0 0,0 false
V100135

Nut
V100136

Bolt


Remove the bolt, nut and No. 3 instrument panel to cowl brace sub-assembly.


Hide 82877 11.REMOVE ECU INTEGRATION BOX RH (for RHD)

a.

Disconnect each connector.


b.
E455747

Disengage the clamp.


c.
E455748C01
0,0 0,0 false
V100135

Nut
V100136

Bolt


Remove the 2 nuts, bolt and ECU integration box RH.


Hide 89111 12.REMOVE CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU) (for RHD)

a.
E455749C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 2 claws to remove the central gateway ECU (network gateway ECU) as shown in the illustration.

NOTICE:
·

If the ECU integration box RH is deformed or damaged, replace it.

·

Do not bend the 2 claws more than necessary.