This DTC is output when an open circuit or short occurs in the communication line between an rear corner ultrasonic sensor LH and the rear center ultrasonic sensor LH, or when a malfunction occurs in a rear corner ultrasonic sensor LH.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AE687 | Ultrasonic Sensor (Rear Left Corner) Missing Message | Rear corner ultrasonic sensor LH lost communication | ·
Rear corner ultrasonic sensor LH ·
Harness or connector ·
Clearance warning ECU assembly |
Perform registration after replacing or removing and installing the ultrasonic sensor or clearance warning ECU assembly.
If a DTC is detected again after the repair, turn the ignition switch to ON and turn the TOYOTA parking assist-sensor system on, and then clear the DTC.
If C1AE796 is output at the same time, check C1AE796 first.
Register the TOYOTA parking assist-sensor system.
| Proceed to |
|---|
| NEXT |
NEXT
According to the display on the GTS, check for DTCs.
According to the display on the GTS, clear the DTCs.
Recheck for DTCs.
| Symptoms | DTC Detection | |||
|---|---|---|---|---|
| C1AE987 | C1AE887 | C1AE787 | C1AE687 | |
| Symptom 1 | Not output | Not output | Not output | Not output |
| Symptom 2 | Output | Output | Output | Output |
| Symptom 3 | Not output | Output | Output | Output |
| Symptom 4 | Not output | Not output | Output | Output |
| Symptom 5 | Not output | Not output | Not output | Output |
| Result | Proceed to |
|---|---|
| Listed under symptom 1 in combination table | A |
| Listed under symptom 2 in combination table | B |
| Listed under symptom 3 in combination table | C |
| Listed under symptom 4 in combination table | D |
| Listed under symptom 5 in combination table | E |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C
D
E
Disconnect the V2 rear center ultrasonic sensor LH connector.
Disconnect the V1 rear corner ultrasonic sensor LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| V2-1 (BO) - V1-4 (BI) | Always | Below 1 Ω |
| V2-2 (SO) - V1-5 (SI) | Always | Below 1 Ω |
| V2-3 (EO) - V1-6 (EI) | Always | Below 1 Ω |
| V2-1 (BO) or V1-4 (BI) - Body ground | Always | 10 kΩ or higher |
| V2-2 (SO) or V1-5 (SI) - Body ground | Always | 10 kΩ or higher |
| V2-3 (EO) or V1-6 (EI) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the rear corner ultrasonic sensor LH.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Rear)>REMOVAL
Inspect the rear corner ultrasonic sensor LH.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Rear)>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the rear corner ultrasonic sensor LH with a new or normally functioning one.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Rear)>REMOVAL
To check if the ultrasonic sensor is functioning correctly, replace it with another ultrasonic sensor.
| Proceed to |
|---|
| NEXT |
NEXT
According to the display on the GTS, check for DTCs.
According to the display on the GTS, clear the DTCs.
Recheck for DTCs.
| Result | Proceed to |
|---|---|
| No DTC is output | A |
| "C1AE687" is output | B |
A
B
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>CLEARANCE WARNING ECU (for RHD)>REMOVAL