The accumulator pressure sensor is built into the brake booster with master cylinder assembly and detects the accumulator pressure.
If the No. 1 skid control ECU (brake booster with master cylinder assembly) detects that the accumulator pressure sensor value is below the threshold, operation of the motor relay is requested and the pump motor built into the brake booster with accumulator pump assembly operates.
Brake pressure sensor "C": Accumulator pressure sensor
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| C05732A | Brake Pressure Sensor "C" Signal Stuck In Range | When the pump motor is operating, the accumulator pressure sensor signal does not change for 14 seconds or more. | No. 1 skid control ECU (brake booster with master cylinder assembly) | Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) |
After replacing the No. 1 skid control ECU (brake booster with master cylinder assembly), perform "Calibration".
Turn the ignition switch to ON.
Depress the brake pedal 10 times or more to operate the pump motor.
After the pump motor stops, check for DTCs.
| Result | Proceed to |
|---|---|
| DTC C05732A is not output. | A |
| DTC C05732A is output. | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
for LHD: Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for HV Model LHD)>REMOVAL
for RHD: Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for HV Model RHD)>REMOVAL