Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model) › from 2020.11
RM37A0E _54 Brake _086868 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0421002 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model)  C059749  Brake System Control Module "A" Internal Electronic Failure  C12F662  Left Front Wheel ABS Hold Solenoid / Right Front Wheel ABS Hold Solenoid Signal Compare Failure  C12F762  Left Rear Wheel ABS Hold Solenoid / Right Rear Wheel ABS Hold Solenoid Signal Compare Failure  C13BF62  Brake Pressure Control Solenoid "A" / "B" Signal Compare Failure  


DESCRIPTION

The solenoid relay and solenoid valves are built into the brake actuator assembly.

The solenoid valves control the brake fluid pressure at each wheel cylinder.

When these DTCs are stored, the fail-safe function operates and the solenoid relay is turned off to prevent the solenoid valves from operating.

HINT:
·

Brake pressure control solenoid "A": Solenoid SM1

·

Brake pressure control solenoid "B": Solenoid SM2



DTC No. Detection Item DTC Detection Condition Trouble Area Note
C059749 Brake System Control Module "A" Internal Electronic Failure When the +BS terminal voltage is from 9.5 to 17.4 V and the solenoid relay is ON, the relay contact is ON and the pump motor is in a low voltage state continuously for 0.1 seconds or more. No. 2 skid control ECU (brake actuator assembly) Output ECU: No. 2 skid control ECU (brake actuator assembly)
C12F662 Left Front Wheel ABS Hold Solenoid / Right Front Wheel ABS Hold Solenoid Signal Compare Failure A difference in holding solenoid (SFLH) and holding solenoid (SFRH) output accuracy continues for 0.2 seconds or more. No. 2 skid control ECU (brake actuator assembly) Output ECU: No. 2 skid control ECU (brake actuator assembly)
C12F762 Left Rear Wheel ABS Hold Solenoid / Right Rear Wheel ABS Hold Solenoid Signal Compare Failure A difference in holding solenoid (SRLH) and holding solenoid (SRRH) output accuracy continues for 0.2 seconds or more. No. 2 skid control ECU (brake actuator assembly) Output ECU: No. 2 skid control ECU (brake actuator assembly)
C13BF62 Brake Pressure Control Solenoid "A" / "B" Signal Compare Failure A difference in master cylinder cut solenoid (SM1) and master cylinder cut solenoid (SM2) output accuracy continues for 0.2 seconds or more. No. 2 skid control ECU (brake actuator assembly) Output ECU: No. 2 skid control ECU (brake actuator assembly)

CAUTION / NOTICE / HINT

NOTICE:

After replacing the No. 2 skid control ECU (brake actuator assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)>UTILITY


PROCEDURE