If a malfunction is detected in the power supply circuit, the No. 1 skid control ECU (brake booster with master cylinder assembly) power source voltage drops, or there is insufficient voltage to operate the main relay, the No. 1 skid control ECU (brake booster with master cylinder assembly) will store these DTCs.
If the auxiliary battery voltage is temporarily low, these DTCs may be stored.
DTC C125600 may also be memorized if there is a drop in power source voltage.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| C110E14 | Brake Booster Motor "A" Supply Voltage Circuit Short to Ground or Open | When the voltage at terminal +BI1 is more than 7.3 V, the voltage at terminal MRI1 is less than 5.7 V for 1 second or more. | ·
Improperly connected connector, deformation or corrosion of terminals ·
Wire harness and connector ·
No. 1 skid control ECU (brake booster with master cylinder assembly) |
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) |
Inspect the fuses for circuits related to this system before performing the following procedure.
Before performing troubleshooting, make sure to confirm that the auxiliary battery voltage is normal.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
After replacing the No. 1 skid control ECU (brake booster with master cylinder assembly), perform "Calibration".
Check the DTCs that are output.
| Result | Proceed to |
|---|---|
| Only DTC C110E14 is output. | A |
| DTCs other than C110E14 are output. | B |
A
B
| *a | Front view of wire harness connector
(to No. 1 Skid Control ECU (Brake Booster with Master Cylinder Assembly)) |
Turn the ignition switch off.
Make sure that there is no looseness at the locking part and the connecting part of the connector.
The connector is securely connected.
Disconnect the A44 No. 1 skid control ECU (brake booster with master cylinder assembly) connector.
Check both the connector case and the terminals for deformation and corrosion.
No deformation or corrosion.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A44-14 (+BI1) - Body ground | Always | 11 to 14 V |
| A44-1 (MRI1) - Body ground | Always | 11 to 14 V |
| Result | Proceed to |
|---|---|
| 11 to 14 V. | A |
| Below 11 V. | B |
A
for LHD: Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for HV Model LHD)>REMOVAL
for RHD: Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for HV Model RHD)>REMOVAL
B