Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model) › from 2020.11
RM37A0E _54 Brake _086868 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0421002 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model)  C141C49  Brake Booster Motor "A" Control Internal Electronic Failure  


DESCRIPTION

Refer to DTC C059400.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)>C059400

DTC No. Detection Item DTC Detection Condition Trouble Area Note
C141C49 Brake Booster Motor "A" Control Internal Electronic Failure Either of the following is detected:
·

When the voltage at terminal +BI1 is between 7.3 and 16.6 V, overcurrent is detected in the motor relay for 0.054 seconds or more.

·

Overcurrent is detected in the motor fail-safe relay for 0.054 seconds or more.


No. 1 skid control ECU (brake booster with master cylinder assembly) Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly)

CAUTION / NOTICE / HINT

NOTICE:

After replacing the No. 1 skid control ECU (brake booster with master cylinder assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)>UTILITY


PROCEDURE

1.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY

NEXT

END