The No. 1 skid control ECU (brake booster with master cylinder assembly) controls braking force according to the hybrid control system regenerative braking force and provides the hydraulic pressure necessary for operating the master cylinder and each wheel cylinder according to the servo pressure sensor.
Brake pressure control solenoid "E": Solenoid SSA
Brake pressure control solenoid "F": Solenoid SGH
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| C15057E | Brake Pressure Control solenoid "E" Actuator Stuck On | When all of the following conditions are met, there is an SSA valve malfunction (stuck closed, etc.).
·
The vehicle was driven before the ignition switch was turned off. ·
90 seconds have elapsed since the ignition switch was turned off. ·
The vehicle is stopped and the shift position is P. |
Brake booster with master cylinder assembly | Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) |
| C150B7E | Brake Pressure Control solenoid "F" Actuator Stuck On | When all of the following conditions are met, there is a SGH valve malfunction (stuck closed, etc.).
·
The vehicle was driven before the ignition switch was turned off. ·
90 seconds have elapsed since the ignition switch was turned off. ·
The vehicle is stopped and the shift position is P. |
Brake booster with master cylinder assembly | Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) |
After replacing the No. 1 skid control ECU (brake booster with master cylinder assembly), perform "Calibration".
Check the DTCs that are output.
| Result | Proceed to |
|---|---|
| Only DTCs C15057E and/or C150B7E are output. | A |
| DTCs other than C15057E and/or C150B7E are output. | B |
A
for LHD: Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for HV Model LHD)>REMOVAL
for RHD: Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for HV Model RHD)>REMOVAL
B