Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE SYSTEM (for HV Model) › from 2020.11
RM37A0E _54 Brake _086873 PARKING BRAKE _0420958 ELECTRIC PARKING BRAKE SYSTEM(for HV Model) C

PARKING BRAKE  ELECTRIC PARKING BRAKE SYSTEM(for HV Model)  C059704  Brake System Control Module "A" System Internal Failure  C059746  Brake System Control Module "A" Calibration / Parameter Memory Failure  C13CF1C  Left Electric Parking Brake Actuator Current Sensor Circuit Voltage Out of Range  C13D41C  Right Electric Parking Brake Actuator Current Sensor Circuit Voltage Out of Range  


DESCRIPTION

The following DTCs are stored when a malfunction occurs in the No. 2 skid control ECU (brake actuator assembly).

DTC No. Detection Item DTC Detection Condition Trouble Area Memory Note
C059704 Brake System Control Module "A" System Internal Failure No. 2 skid control ECU (brake actuator assembly) internal malfunction No. 2 skid control ECU (brake actuator assembly) DTC stored An electric parking brake system malfunction is displayed on the multi-information display.
C059746 Brake System Control Module "A" Calibration / Parameter Memory Failure No. 2 skid control ECU (brake actuator assembly) internal malfunction No. 2 skid control ECU (brake actuator assembly) DTC stored An electric parking brake system malfunction is displayed on the multi-information display.
C13CF1C Left Electric Parking Brake Actuator Current Sensor Circuit Voltage Out of Range No. 2 skid control ECU (brake actuator assembly) internal malfunction No. 2 skid control ECU (brake actuator assembly) DTC stored An electric parking brake system malfunction is displayed on the multi-information display.
C13D41C Right Electric Parking Brake Actuator Current Sensor Circuit Voltage Out of Range No. 2 skid control ECU (brake actuator assembly) internal malfunction No. 2 skid control ECU (brake actuator assembly) DTC stored An electric parking brake system malfunction is displayed on the multi-information display.

CAUTION / NOTICE / HINT

NOTICE:
·

To ensure that the electric parking brake does not operate, wait for 3 minutes or more with the ignition switch off, the driver door closed, and the brake pedal not depressed, then disconnect each connector, fuse and relay.

·

After replacing the No. 2 skid control ECU (brake actuator assembly), perform calibration (linear solenoid valve offset learning, SM solenoid valve offset learning, brake pedal stroke sensor assembly zero point calibration, system information memorization, and yaw rate and acceleration sensor zero point calibration) after performing "Reset Memory".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)>UTILITY

·

When replacing the No. 2 skid control ECU (brake actuator assembly), operate the electric parking brake switch (electric parking brake switch assembly) as the parking brake indicator light (red) blinks when the ignition switch is first turned ON.



PROCEDURE

1.REPLACE NO. 2 SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY)
a.

Replace the No. 2 skid control ECU (brake actuator assembly).

for LHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for HV Model LHD)>REMOVAL

for RHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for HV Model RHD)>REMOVAL

Result:
Proceed to
NEXT




NEXT

END