Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE SYSTEM (for HV Model) › from 2020.11
RM37A0E _54 Brake _086873 PARKING BRAKE _0420958 ELECTRIC PARKING BRAKE SYSTEM(for HV Model) J

PARKING BRAKE  ELECTRIC PARKING BRAKE SYSTEM(for HV Model)  Brake Warning Light (Yellow) Remains On  


DESCRIPTION

This procedure is for troubleshooting when the brake warning light (yellow) remains on but no DTCs are output.

The No. 2 skid control ECU (brake actuator assembly) controls the brake warning light (yellow) in the combination meter assembly via CAN communication.

CAUTION / NOTICE / HINT

NOTICE:
·

To ensure that the electric parking brake does not operate, wait for 3 minutes or more with the ignition switch off, the driver door closed, and the brake pedal not depressed, then disconnect each connector, fuse and relay.

·

After replacing the No. 2 skid control ECU (brake actuator assembly), perform calibration (linear solenoid valve offset learning, SM solenoid valve offset learning, brake pedal stroke sensor assembly zero point calibration, system information memorization, and yaw rate and acceleration sensor zero point calibration) after performing "Reset Memory".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)>UTILITY

·

When replacing the No. 2 skid control ECU (brake actuator assembly), operate the electric parking brake switch (electric parking brake switch assembly) as the parking brake indicator light (red) blinks when the ignition switch is first turned ON.



PROCEDURE

1.CHECK VEHICLE CONTROL HISTORY (ELECTRIC PARKING BRAKE SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Enter the following menus: Chassis / Brake/EPB / Utility / Vehicle Control History (RoB).


d.

d. Using the GTS, check for Vehicle Control History.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)>VEHICLE CONTROL HISTORY

Chassis > Brake/EPB > Utility
Tester Display
Vehicle Control History (RoB)
50005 435 1055
HINT:

If vehicle control history is stored when the electric parking brake system is suspended, the brake warning light (yellow) illuminates.



Result:
Result Proceed to
There is no vehicle control history for when the electric parking brake system was suspended. A
There is vehicle control history for when the electric parking brake system was suspended. B



A

2.INSPECT COMBINATION METER ASSEMBLY (BRAKE WARNING LIGHT (YELLOW))

B

ERFORM TROUBLESHOOTING AND REPAIR REGARDING VEHICLE CONTROL HISTORY

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)>VEHICLE CONTROL HISTORY

NOTICE:

After performing troubleshooting and repair regarding vehicle control history, clear the vehicle control history.



2.INSPECT COMBINATION METER ASSEMBLY (BRAKE WARNING LIGHT (YELLOW))
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


d.

Perform the Active Test of the combination meter assembly using the GTS.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST

Body Electrical > Combination Meter > Active Test
Tester Display
ECB Warning
50004 409 110

e.

Check the combination meter assembly.

OK:

The brake warning light (yellow) turns on or off in accordance with GTS operation.



Result:
Proceed to
OK
NG



OK

NG