The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ultrasonic sensor removal/installation are shown below.
1.REMOVE FRONT BUMPER ASSEMBLY
89341L
2.REMOVE FRONT CENTER ULTRASONIC SENSOR
The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.
Disconnect the connector.
|
Remove in this Direction |
Disengage the 2 claws and remove the front center ultrasonic sensor as shown in the illustration.
89341K
3.REMOVE FRONT CORNER ULTRASONIC SENSOR
The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.
Disconnect the connector.
|
Remove in this Direction |
Disengage the 2 claws and remove the front corner ultrasonic sensor as shown in the illustration.
89347C
4.REMOVE FRONT CENTER ULTRASONIC SENSOR RETAINER
Perform this procedure only when replacement of the front center ultrasonic sensor retainer is necessary.
When removing the front center ultrasonic sensor retainer, heat the front bumper assembly and front center ultrasonic sensor retainer using a heat light.
The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.
Heat the front bumper assembly and front center ultrasonic sensor retainer using a heat light at the specified temperature for 3 to 5 minutes.
| Item | Temperature |
|---|---|
| Front Bumper Assembly | 40 to 60°C (104 to 140°F) |
| Front Center Ultrasonic Sensor Retainer |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Remove the front center ultrasonic sensor retainer.
89347B
5.REMOVE FRONT CORNER ULTRASONIC SENSOR RETAINER
Perform this procedure only when replacement of the front corner ultrasonic sensor retainer is necessary.
When removing the front corner ultrasonic sensor retainer, heat the front bumper assembly and front corner ultrasonic sensor retainer using a heat light.
The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.
Heat the front bumper assembly and front corner ultrasonic sensor retainer using a heat light at the specified temperature for 3 to 5 minutes.
| Item | Temperature |
|---|---|
| Front Bumper Assembly | 40 to 60°C (104 to 140°F) |
| Front Corner Ultrasonic Sensor Retainer |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Remove the front corner ultrasonic sensor retainer.
89305
6.REMOVE ULTRASONIC SENSOR CUSHION SET
Only perform this procedure when removing and installing the ultrasonic sensor cushion set.
Remove the ultrasonic sensor cushion set as shown in the illustration.
|
Remove in this Direction | - | - |