The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during electrical key and tire pressure warning ECU and receiver removal/installation are shown below.
When replacing the electrical key and tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.
Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DATA LIST / ACTIVE TEST
When replacing the door control and tire pressure warning ECU and receiver or electrical key and tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.
Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DATA LIST / ACTIVE TEST
1.REMOVE REAR NO. 2 SEAT ASSEMBLY
58387B
2.REMOVE REAR FLOOR FINISH PLATE
72138M
3.REMOVE REAR OUTER SEAT TRACK BRACKET COVER LH
67918A
4.REMOVE REAR DOOR SCUFF PLATE LH
62332C
5.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
Disconnect the rear door opening trim weatherstrip LH.
64713F
6.REMOVE FRONT DECK SIDE TRIM COVER LH
64715E
7.REMOVE NO. 2 DECK SIDE TRIM COVER
64974
8.REMOVE DECK TRIM POCKET COVER
64725F
9.REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
66311
10.REMOVE ROPE HOOK
64740C
11.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
89740A
12.REMOVE SMART DOOR CONTROL RECEIVER ASSEMBLY (w/o Tire Pressure Warning System)
Do not drop, strike or otherwise subject the smart door control receiver assembly to impact.
If the smart door control receiver assembly is subjected to an impact, replace it with a new one.
Remove the bolt.
Disengage the 2 guides.
Disconnect the connector to remove the smart door control receiver assembly.
897B0A
13.REMOVE ELECTRICAL KEY AND TIRE PRESSURE WARNING ECU AND RECEIVER (w/ Tire Pressure Warning System)
Do not drop, strike or otherwise subject the electrical key and tire pressure warning ECU and receiver to impact.
If the electrical key and tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.
Remove the bolt.
Disengage the 2 guides.
Disconnect the connector to remove the electrical key and tire pressure warning ECU and receiver.