The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during air conditioning amplifier assembly removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
1.REMOVE CONSOLE BOX ASSEMBLY
73900
2.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
78110K
3.REMOVE ACCELERATOR PEDAL(W/SENSOR) ROD ASSEMBLY (for LHD)
for 2GR-FKS:
Click hereEngine / Hybrid System>2GR-FKS (ENGINE CONTROL)>ACCELERATOR PEDAL>REMOVAL
for A25A-FXS, A25B-FXS:
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>ACCELERATOR PEDAL SENSOR>REMOVAL
55434F
4.REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL
58816B
5.REMOVE FRONT CONSOLE BOX INSERT (for LHD)
58817A
6.REMOVE FRONT NO. 2 CONSOLE BOX INSERT (for RHD)
88650N
7.REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY
for LHD:
Disengage the 2 clamps.
Remove the screw.
|
Remove in this Direction |
Disengage the guide as shown in the illustration.
for RHD:
Disengage the clamp.
Remove the screw.
|
Remove in this Direction |
Disengage the guide as shown in the illustration.
Disconnect the 5 connectors to remove the air conditioning amplifier assembly.