Home › Engine / Hybrid System › A25A-FXS, A25B-FXS (EMISSION CONTROL) › EGR COOLER › from 2021.10
RM37A0E _51 Engine / Hybrid System _086908 A25A-FXS, A25B-FXS EMISSION CONTROL _0416573 EGR COOLER A

A25A-FXS, A25B-FXS EMISSION CONTROL  EGR COOLER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during EGR cooler assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: Learning can also be performed using the GTS.

Click here(Click here)

Auxiliary battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Control System (Click here)
Parking Support Brake System*1
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)
Replacement of inverter with converter assembly Resolver learning
·

DTCs are stored

·

Slight vibration at a vehicle speed of 5 km/h (3 mph) or less

·

Shock or vibration during acceleration


for 2WD:(Click here)
for 4WD/AWD:(Click here)
Replacement of ECM Perform Vehicle Identification Number (VIN) registration DTC is output (Click here)
Gas leak from exhaust system is repaired Perform Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


PROCEDURE

Hide 1.DRAIN ENGINE COOLANT (for Engine)

Hide G9200 2.REMOVE INVERTER WITH CONVERTER ASSEMBLY

Hide 25680 3.REMOVE EGR COOLER ASSEMBLY (for A25A-FXS)

a.
A472567C08
1.104,1.5 1.104,1.229 1.104,1.229 1.333,1.021 true 2.323,1.292 2.698,1.292 true 2.792,1.167 3,1.354 0.208,0.188 10 true *1 1.021,1.51 1.198,1.688 0.177,0.177 10 true *2
*1 No. 3 Water By-pass Hose
*2 No. 4 Water By-pass Hose


Slide the 2 clips and disconnect the No. 3 water by-pass hose and No. 4 water by-pass hose from the EGR cooler assembly.


b.
A472568C06
2.635,1.688 2.896,1.906 0.26,0.219 10 true *a
*a Bolt or Nut


Type A:

i.

Remove the 3 bolts, 2 nuts and EGR cooler assembly from the cylinder head sub-assembly and EGR valve assembly.



c.

Type B:

i.

Remove the 2 bolts, 3 nuts and EGR cooler assembly from the cylinder head sub-assembly and EGR valve assembly.



d.
A472569C05
0.604,1.583 0.906,1.583 false 2.375,0.698 2.375,0.969 false 2.323,1.021 2.563,1.229 0.24,0.208 10 false *1 0.406,1.5 0.781,1.844 0.375,0.344 10 false *2
*1 EGR Valve Gasket
*2 EGR Cooler Gasket


Remove the EGR valve gasket from the EGR cooler assembly.


e.

Remove the EGR cooler gasket from the EGR cooler assembly.


Hide 25680 4.REMOVE EGR COOLER ASSEMBLY (for A25B-FXS)

a.
A482404C02
1,1.563 1,1.396 1,1.396 1.396,1.125 true 2.24,1.219 2.677,1.219 true 2.792,1.125 3,1.313 0.208,0.188 10 true *1 0.927,1.594 1.156,1.813 0.229,0.219 10 true *2
*1 No. 3 Water By-pass Hose
*2 No. 4 Water By-pass Hose


Slide the 2 clips and disconnect the No. 3 water by-pass hose and No. 4 water by-pass hose from the EGR cooler assembly.


b.
A482405C03
2.635,1.698 2.854,1.906 0.219,0.208 10 true *a
*a Bolt or Nut


Type A:

i.

Remove the 3 bolts, 2 nuts and EGR cooler assembly from the cylinder head sub-assembly and EGR valve assembly.



c.

Type B:

i.

Remove the 2 bolts, 3 nuts and EGR cooler assembly from the cylinder head sub-assembly and EGR valve assembly.



d.
A482406C03
0.667,1.521 0.969,1.521 false 2.417,0.656 2.417,0.927 false 2.354,0.927 2.594,1.135 0.24,0.208 10 false *1 0.51,1.458 0.885,1.802 0.375,0.344 10 false *2
*1 EGR Valve Gasket
*2 EGR Cooler Gasket


Remove the EGR valve gasket from the EGR cooler assembly.


e.

Remove the EGR cooler gasket from the EGR cooler assembly.