2008-2009 Hilux TRD · Service Manual Intercooler

Water Pump Assembly

Intercooler · Vehicles built Up to Oct 2008

Versions by build date: Up to Oct 2008 From Oct 2008

COMPONENTS
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seatbelt pretensioner activation.
HINT:
Obtain the audio system PIN from the vehicle owner, if applicable. Otherwise the audio system will be inoperable when the battery cable is reconnected.
2. REMOVE FRONT FENDER LINER LH ( Click Here )
3. REMOVE FRONT FENDER LINER RH
HINT:
Use the same procedures described for the LH side.
4. REMOVE FRONT BUMPER ASSEMBLY ( Click Here )
5. DRAIN COOLANT ( Click Here )
6. REMOVE WATER PUMP ASSEMBLY
(a) Disconnect the coolant hose and wiring connector.
-
(b) Remove the 4 screws and remove the pump assembly.
-
(c) Loosen the clamps and remove the pump from the water pump stay.
-
INSPECTION
1. INSPECT WATER PUMP
(a) Visually check the pump for damage or cracks.
-
(b) Connect the pump to 12V and listen for abnormal noise.
-
(c) Check pump volume.
(1) Attach a hose to the pump inlet and outlet ports.
(2) Connect the inlet hose to a water source.
(3) Connect the outlet hose to a measuring container.
(4) Connect battery positve (+) to the water pump terminal 1 and negative (-) to terminal 2 and run the pump for 15 seconds.
(5) Measure the water in the container.
Water volume:
4.0 Litres (4.2 US qts, 3.5 Imp. qts) per 15 seconds


-
INSTALLATION
1. INSTALL WATER PUMP ASSEMBLY
(a) Fit the water pump on to the water pump stay with the clamps. Do not tighten the clamps.
-
(b) Install the pump assembly with the 4 screws.
Torque:
12 N*m (122 kgf*cm, 9.0 ft.*lbf)
-
(c) Connect the coolant hose and wiring connector.
-
(d) Reposition the pump as required and tighten the clamps.
Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)
-
2. ADD COOLANT ( Click Here )
3. CHECK FOR COOLANT LEAKS
(a) Check for engine coolant leaks ( Click Here )
-
4. INSTALL FRONT BUMPER ASSEMBLY ( Click Here )
5. INSTALL FRONT FENDER LINER LH ( Click Here )
6. INSTALL FRONT FENDER LINER RH
HINT:
Use the same procedures described for the LH side.
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
8. PERFORM INITIALISATION
(a) Enter the audio system PIN, if applicable. Refer to Section 1-8 "Audio System" in the TRD Hilux Driver's Manual for programming information.
-
(b) Calibrate the multi-information display compass. Refer to Section 1-10 "Other Equipment" in the TRD Hilux Driver's Manual for calibrating information.
-