Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM

POWER WINDOW CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Use these procedures to troubleshoot the power window control system.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      10 to 14 V

      If the voltage is below 10 V, recharge or replace the battery before proceeding.

    NEXT


    3.PROBLEM SYMPTOMS TABLE

      Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B


    B.
    Go to step 5
    A


    4.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. Terminals of ECU (Click here)

    2. On-vehicle Inspection (Click here)

    3. Inspection

      1. Inspect master switch (Click here)

      2. Inspect front passenger switch (Click here)

      3. Inspect rear switch (Click here)

      4. Inspect power window motor (Click here)


    NEXT


    5.REPAIR OR REPLACE

      NEXT


      6.CONFIRMATION TEST

        NEXT

        END