CYLINDER HEAD > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE NO. 1 ENGINE UNDER COVER (for 4WD and Pre-Runner) |
Remove the 4 bolts and No. 1 engine under cover.
| 3. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug.
![]() |
Drain the coolant by removing the reservoir cap and, using a wrench, remove the vent plug.
Loosen the cylinder block drain cock plug.

| 4. DRAIN ENGINE OIL |
Remove the oil filter cap.
Remove the oil drain plug, and drain the engine oil from the oil pan.
| 5. LOOSEN FUEL TANK CAP ASSEMBLY |
| 6. REMOVE INTAKE MANIFOLD (w/ EGR Cooler) |
| 7. REMOVE INTAKE MANIFOLD (w/ EGR System without EGR Cooler) |
| 8. REMOVE INTAKE MANIFOLD (w/o EGR System) |
| 9. REMOVE GLOW PLUG ASSEMBLY (w/ EGR Cooler) |
| 10. REMOVE GLOW PLUG ASSEMBLY (w/o EGR Cooler) |
| 11. REMOVE COMMON RAIL ASSEMBLY (w/ EGR Cooler) |
| 12. REMOVE COMMON RAIL ASSEMBLY (w/o EGR Cooler) |
| 13. REMOVE TIMING BELT |
| 14. REMOVE INJECTOR ASSEMBLY (w/ EGR Cooler) |
| 15. REMOVE INJECTOR ASSEMBLY (w/o EGR Cooler) |
| 16. REMOVE TURBOCHARGER SUB-ASSEMBLY (w/ EGR Cooler) |
| 17. REMOVE TURBOCHARGER SUB-ASSEMBLY (w/o EGR Cooler) |
| 18. DISCONNECT COOLER COMPRESSOR ASSEMBLY (w/ Air Conditioning System) |
Remove the 4 bolts and disconnect the cooler compressor.
| 19. REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET (w/ Air Conditioning System) |
Remove the 4 bolts and No. 1 compressor mounting bracket.
| 20. REMOVE EXHAUST MANIFOLD |
![]() |
Remove the 8 nuts and exhaust manifold.
| 21. DISCONNECT WIRE HARNESS |
| 22. REMOVE CAMSHAFT TIMING PULLEY |
![]() |
Remove the bolt of the camshaft timing pulley by holding the camshaft with a wrench.
Remove the camshaft timing pulley.
| 23. REMOVE NO. 1 TIMING BELT IDLER SUB-ASSEMBLY |
| 24. REMOVE NO. 2 TIMING BELT COVER |
Remove the 4 bolts, nuts and No. 2 timing belt cover.
| 25. REMOVE CYLINDER BLOCK INSULATOR (w/ EGR Cooler) |
![]() |
Remove the cylinder block insulator from the cylinder head.
| 26. REMOVE CAMSHAFT |
![]() |
Face the key groove of the camshaft upward by turning the camshaft with a wrench.
![]() |
Uniformly loosen the 15 bearing cap bolts in several passes in the sequence shown in the illustration.
Remove the 5 bearing caps, oil seal and 2 camshafts.
| 27. REMOVE CYLINDER HEAD SUB-ASSEMBLY |
![]() |
Uniformly loosen and remove the 18 cylinder head bolts in several passes in the sequence shown in the illustration.
Lift the cylinder head from the dowels on the cylinder block, and place the cylinder head on wooden blocks on a bench.
| 28. REMOVE CYLINDER HEAD GASKET |