DTC P2009 Intake Manifold Runner Control Circuit Low (Bank 1) |
DTC P2010 Intake Manifold Runner Control Circuit High (Bank 1) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P2009 | Open in VSV for No. 1 swirl control valve circuit for 0.5 seconds (2 trip detection logic) |
|
| P2010 | Short in VSV for No. 1 swirl control valve circuit for 0.5 seconds (2 trip detection logic) |
|
| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (ACTIVATE THE VSV FOR SWIRL CONTROL VALVE) |
![]() |
Connect the intelligent tester to the DLC3.
Disconnect the vacuum hoses from the VSV for No. 1 swirl control valve.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine / Active Test / Activate the VSV for Swirl Control Valve.
Check the VSV operation when it is operated using the intelligent tester.
| Tester Operation | Specified Condition |
| VSV ON | Air from port E flows out through port F |
| VSV OFF | Air from port E flows out through air filter |
|
| ||||
| NG | |
| 2.INSPECT VACUUM SWITCHING VALVE FOR NO. 1 SWIRL CONTROL VALVE (RESISTANCE) |
![]() |
Disconnect the S9 VSV for No. 1 swirl control valve connector.
Measure the resistance of the VSV for No. 1 swirl control valve.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 33 to 39 Ω |
|
| ||||
| OK | |
| 3.INSPECT VACUUM SWITCHING VALVE FOR NO. 1 SWIRL CONTROL VALVE (POWER SOURCE VOLTAGE) |
![]() |
Disconnect the S9 VSV for No. 1 swirl control valve connector.
Turn the ignition switch ON.
Measure the voltage of the wire harness side connector and body ground.
| Tester Connection | Specified Condition |
| S9-2 - Body ground | 11 to 14 V |
|
| ||||
| NG | |
| 4.CHECK HARNESS AND CONNECTOR (VSV FOR NO. 1 SWIRL CONTROL VALVE - INTEGRATION RELAY) |
![]() |
Remove the integration relay from the engine room junction block (Click here).
Disconnect the 1J integration relay connector.
Disconnect the S9 VSV for No. 1 swirl control valve connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| 1J-5 - S9-2 | Below 1 Ω |
| Tester Connection | Specified Condition |
| 1J-5 - S9-2 | Below 1 Ω |
| 1J-5 or S9-2 - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 5.CHECK HARNESS AND CONNECTOR (VACUUM SWITCHING VALVE FOR NO. 1SWIRL CONTROL VALVE - ECM) |
![]() |
Disconnect the S9 VSV for No. 1 swirl control valve connector.
Disconnect the E8 ECM connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| S9-1 - SCV (E8-15) | Below 1 Ω |
| Tester Connection | Specified Condition |
| S9-1 or SCV (E8-15) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||