AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEMS ANALYSIS AND SYMPTOM CHECK |
| |||||
| 3.INSPECT BATTERY VOLTAGE |
| |||||
| 4.CHECK FOR DTC |
Check for DTCs and note any codes that are output.
Delete the DTCs.
Recheck for DTCs. Based on the DTCs output above, try to force output of the air conditioning system DTC by simulating the conditions indicated by the DTC.
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| |||||
| 5.PROBLEM SYMPTOMS TABLE (Click here) |
| Result | Proceed to |
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
|
| ||||
| |||||
| 6.OVERALL ANALYSIS AND TROUBLESHOOTING |
Actuator Check (Click here).
Terminals of ECU (Click here).
On-vehicle Inspection (Click here).
| |||||
| 7.ADJUST, REPAIR OR REPLACE |
|
| ||||
|---|---|---|---|---|---|