DTC P0122 Throttle / Pedal Position Sensor / Switch "A" Circuit Low Input |
DTC P0123 Throttle / Pedal Position Sensor / Switch "A" Circuit High Input |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0122 | Throttle position sensor output (VLU) is less than 0.2 V (1 trip detection logic) |
|
| P0123 | Throttle position sensor output (VLU) is more than 4.8 V (1 trip detection logic) |
|


| 1.CHECK HARNESS AND CONNECTOR (THROTTLE POSITION SENSOR - ECM) |
![]() |
Disconnect the E7 and E8 ECM connectors.
Disconnect the T2 throttle position sensor connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| VC (E8-18) - VC (T2-1) | Below 1 Ω |
| VLU (E7-29) - VAF (T2-3) | Below 1 Ω |
| E2 (E8-28) - E2 (T2-2) | Below 1 Ω |
| Tester Connection | Specified Condition |
| VC (E8-18) or VC (T2-1) - Body ground | 10 kΩ or higher |
| VLU (E7-29) or VAF (T2-3) - Body ground | 10 kΩ or higher |
| E2 (E8-28) or E2 (T2-2) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.INSPECT ECM (VC VOLTAGE) |
![]() |
Disconnect the T2 throttle position sensor connector.
Turn the ignition switch ON.
Measure the voltage of the throttle position sensor connector.
| Tester Connection | Specified Condition |
| VC (T2-1) - E2 (T2-2) | 4.5 to 5.5 V |
|
| ||||
| OK | |
| 3.REPLACE DIESEL THROTTLE BODY ASSEMBLY |
| NEXT | |
| 4.CHECK IF DTC OUTPUT RECURS |
Clear the DTC(s) (Click here).
Start the engine.
Let the engine idle for 60 seconds.
Repeat quick engine revving to 2,500 rpm for 30 seconds.
Check for DTC(s).
| Display (DTC Output) | Proceed to |
| P0122 and/or P0123 | A |
| No output | B |
|
| ||||
| A | ||
| ||