DTC P0046 Turbocharger / Supercharger Boost Control Solenoid Circuit Range / Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0046 | Either of following conditions met:
|
|

| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO P0046) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine / DTC.
Read the DTCs.
| Display (DTC Output) | Proceed to |
| P0046 | A |
| P0046 and other DTCs | B |
|
| ||||
| A | |
| 2.INSPECT TURBOCHARGER SUB-ASSEMBLY (DC MOTOR OPERATION) |
Turn the ignition switch ON.
Turn the ignition switch OFF and check the DC motor operation.

|
| ||||
| OK | ||
| ||
| 3.INSPECT TURBO MOTOR DRIVER |
Voltage Inspection
![]() |
Turn the ignition switch ON (IG).
Measure the voltage between the terminals of the turbo motor driver connector.
| Tester Connection | Specified Condition |
| +B (T8-3) - GND (T8-4) | 11 to 14 V |
Output Waveform Inspection
![]() |
Turn the ignition switch ON (IG).
Check the waveform of the ECM connectors using an oscilloscope.
| Tester Connection | Condition | Specified Condition |
| VNTI (T8-2) - GND (T8-4) | Ignition switch ON | Correct waveform is as shown |
|
| ||||
| OK | |
| 4.INSPECT TURBOCHARGER SUB-ASSEMBLY (DC MOTOR RESISTANCE) |
![]() |
Disconnect the T10 DC motor connector.
Measure the resistance of the DC motor.
| Tester Connection | Specified Condition |
| M+ (2) - M- (1) | 1 to 100 Ω |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (DC MOTOR - TURBO MOTOR DRIVER) |
![]() |
Disconnect the T10 DC motor connector.
Disconnect the T8 turbo motor drive connector.
Measure the resistance of the wire harness side connector.
| Tester Connections | Specified Conditions |
| M+ (T8-12) - M+ (T10-2) | Below 1 Ω |
| M- (T8-5) - M- (T10-1) | Below 1 Ω |
| Tester Connections | Specified Conditions |
| M+ (T8-12) or M+ (T10-2) - Body ground | 10 kΩ or higher |
| M- (T8-5) or M- (T10-1) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 6.CHECK IF DTC OUTPUT RECURS (DTC P0046) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Clear the DTC (Click here).
Start the engine.
Perform the test drive.
Enter the following menus: Powertrain / Engine / DTC.
Read the DTCs.
| Display (DTC Output) | Proceed to |
| P0046 | A |
| No output | B |
|
| ||||
| A | ||
| ||