WATER PUMP > INSTALLATION |
| 1. INSTALL WATER PUMP ASSEMBLY |
![]() |
Install a new gasket, the water pump and tension spring bracket with the 6 bolts.
| 2. INSTALL TIMING BELT |
Install the timing belt (Click here).
| 3. INSTALL FAN SHROUD |
![]() |
Install the fan pulley to the water pump.
Install the shroud together with the coupling fan between the radiator and engine.
Install the fluid coupling fan to the fan pulley with the 4 nuts.
Attach the shroud's claws to the radiator as shown in A in the illustration.
Install the shroud with the 2 bolts.
Install the fan and generator V belt, cooler compressor V belt and vane pump V belt (Click here).
Tighten the 4 nuts of the fluid coupling fan.
![]() |
Install the radiator reservoir with the bolt.
Connect the No. 1 and No. 2 water by-pass hoses to the tank upper and lower.
![]() |
Install the oil reservoir with the 3 bolts.
| 4. CONNECT RADIATOR HOSE OUTLET |
| 5. CONNECT RADIATOR HOSE INLET |
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 7. ADD ENGINE COOLANT |
Tighten the radiator drain cock plug by hand.
Tighten the cylinder block drain cock plug.
![]() |
Fill the radiator with TOYOTA Super Long Life Coolant (SLLC) to the reservoir tank's FULL line.
Press the inlet and outlet radiator hoses several times by hand, and then check the level of the coolant.
If the coolant level drops below the LOW line, add TOYOTA SLLC to the FULL line.
Install the radiator reservoir cap.
![]() |
Using a wrench, install the vent plug.
Bleed air from the cooling system.
Warm up the engine until the thermostat opens. While the thermostat is open, circulate the coolant for several minutes.
Maintain the engine speed at 2,500 to 3,000 rpm.
Press the inlet and outlet radiator hoses several times by hand to bleed air.
Stop the engine and wait until the coolant cools down to ambient temperature.
![]() |
After the coolant cools down, check that the coolant level is at the FULL line.
If the coolant level is below the LOW line, add TOYOTA SLLC to the FULL line.
| 8. CHECK FOR ENGINE COOLANT LEAKS |
Check for engine coolant leaks .
| 9. INSTALL NO. 1 ENGINE UNDER COVER |
Install the under cover with the 8 bolts.