DTC C1426 Stop Light Switch OFF Stuck Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1426 | When the brake pedal load sensing switch is on, the master cylinder pressure is 2 MPa or higher and the deceleration calculated from the vehicle speed is 0.2 G or more, the stop light switch is off for 2 seconds or more. |
|
| 1.CHECK STOP LIGHT OPERATION |
Check that the stop light LH and RH come on when the brake pedal is depressed, and go off when the brake pedal is released.
| Condition | Illumination Condition |
| Brake pedal depressed | On |
| Brake pedal released | Off |
|
| ||||
| OK | |
| 2.READ VALUE USING INTELLIGENT TESTER (STOP LIGHT SW/BRAKE PEDAL LOAD SENSING SW) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Stop Light SW | Stop light switch / ON or OFF | ON: Brake pedal depressed OFF: Brake pedal released | - |
| Brake Pedal Load Sensing SW | Brake pedal load sensing switch / ON or OFF | ON: Brake pedal depressed beyond specified point OFF: Brake pedal not depressed beyond specified point | - |
Check that the stop light switch display and brake pedal load sensing switch display observed on the intelligent tester change according to the brake pedal operation.
Slowly depress the brake pedal and check when the stop light switch and brake pedal load sensing switch are turned on.
| Result | Proceed to |
| OK | A |
| NG (Turning on of stop light switch is not confirmed) | B |
| NG (Brake pedal load sensing switch turns on first) | C |
|
| ||||
|
| ||||
| A | |
| 3.RECONFIRM DTC |
Clear the DTC (Click here).
Turn the ignition switch off.
Start the engine.
Depress the brake pedal several times to test the stop light circuit.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | ||
| ||
| 4.INSPECT STOP LIGHT SWITCH ASSEMBLY |
Turn the ignition switch off.
Remove the stop light switch assembly (Click here).
Inspect the stop light switch assembly (Click here).
|
| ||||
| OK | |
| 5.CHECK TERMINAL VOLTAGE (STP TERMINAL) |
Turn the ignition switch off.
Disconnect the skid control ECU (brake actuator assembly) connector.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S25-2 (STP) - Body ground | Brake pedal depressed | 8 to 14 V |
| Brake pedal released | Below 1.5 V |
| *a | Front view of wire harness connector (to Skid Control ECU [Brake Actuator Assembly]) |
|
| ||||
| OK | ||
| ||
| 6.ADJUST BRAKE PEDAL AND STOP LIGHT SWITCH INSTALLATION |
Adjust the brake pedal height and stop light switch installation (Click here).
| NEXT | |
| 7.RECONFIRM DTC |
Clear the DTC (Click here).
Turn the ignition switch off.
Start the engine.
Depress the brake pedal several times to test the stop light circuit.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | ||
| ||