Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM

POWER WINDOW CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Use these procedures to troubleshoot the power window control system.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.PROBLEM SYMPTOMS TABLE
    1. Refer to the Problem Symptoms Table (Click here).

    2. Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B


    B.
    Go to step 5
    A


    4.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. Terminals of ECU (Click here).


    NEXT


    5.REPAIR OR REPLACE
      Result 
      Result
      Proceed to
      Front door window regulator sub-assembly (for driver side) and/or power window regulator master switch assembly replaced or removed/installed
      A
      Front door window regulator sub-assembly (for driver side) and/or power window regulator master switch assembly not replaced or removed/installed
      B


    B.
    Go to step 7
    A


    6.PERFORM INITIALIZATION
    1. Initialize the front door window regulator sub-assembly (for driver side) (Click here).


    NEXT


    7.CONFIRMATION TEST

      NEXT

      END