POWER WINDOW CONTROL SYSTEM (for LHD) > Driver Side Power Window does not Operate with Power Window Master Switch |

| 1.INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY |
![]() |
Remove the motor (Click here).
Apply battery voltage to connector terminals 1 and 2.
Check that the motor gear rotates smoothly as follows.
| Measurement Condition | Specified Condition |
| Battery positive (+) → 1 Battery negative (-) → 2 | Motor gear rotates counterclockwise |
| Battery positive (+) → 2 Battery negative (-) → 1 | Motor gear rotates clockwise |
|
| ||||
| OK | |
| 2.INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (for Driver Switch) |
![]() |
Remove the master switch (Click here).
Measure the resistance of the switch when the switch is operated.
| Tester Connection | Window Lock Switch Condition | Driver Switch Condition | Specified Condition |
| 3 (E) - 9 (DD), 4 (DU) - 6 (B) | Always (ON / OFF) | UP | Below 1 Ω |
| 3 (E) - 4 (DU), 3 (E) - 9 (DD) | Always (ON / OFF) | OFF | Below 1 Ω |
| 3 (E) - 4 (DU), 6 (B) - 9 (DD) | Always (ON / OFF) | DOWN | Below 1 Ω |
| 3 (E) - 4 (DU), 6 (B) - 9 (DD) | Always (ON / OFF) | AUTO DOWN | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (MASTER SWITCH - REGULATOR MOTOR) |

Disconnect the P6 master switch connector.
Disconnect the P7 motor connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| P6-9 (DD) - P7-1 | Below 1 Ω |
| P6-4 (DU) - P7-2 | Below 1 Ω |
| P6-9 (DD) or P7-1 - Body ground | 10 kΩ or higher |
| P6-4 (DU) or P7-2 - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||