MANUAL TRANSMISSION ASSEMBLY > INSTALLATION |
| 1. INSTALL TRANSFER ASSEMBLY |
Install the transfer to the transmission.
Install the 2 clamps and 8 bolts.
| 2. INSTALL MANUAL TRANSMISSION UNIT ASSEMBLY |
![]() |
Align the input shaft with the clutch disc and install the transmission to the engine.
Install the 4 bolts.
| 3. INSTALL STIFFENER PLATE |
![]() |
Install the stiffener plate RH with the 4 bolts.
Install the stiffener plate LH with the 4 bolts.
| 4. INSTALL REAR NO. 1 ENGINE MOUNTING INSULATOR |
![]() |
Install the mounting insulator with the 4 bolts.
| 5. INSTALL NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY |
![]() |
Install the frame crossmember with the 4 bolts and 4 nuts.
Install the 4 set bolts to the rear No. 1 engine mounting insulator.
| 6. INSTALL STARTER ASSEMBLY |
| 7. CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY |
![]() |
Connect the release cylinder with the 2 bolts.
| 8. CONNECT WIRE HARNESS |
Transmission side:
Connect the back-up light switch connector.
Transfer side:
Connect the No. 1, No. 2 and No. 3 transfer indicator switch connectors, and vehicle speed sensor connector.
| 9. INSTALL FRONT EXHAUST PIPE ASSEMBLY |
| 10. INSTALL REAR PROPELLER SHAFT ASSEMBLY |
| 11. INSTALL FRONT PROPELLER SHAFT ASSEMBLY |
| 12. ADD MANUAL TRANSMISSION OIL |
![]() |
| 13. ADD TRANSFER OIL |
Remove the case plug (for filler) and gasket.
Pour oil so that the oil level is between 0 to 5.0 mm (0 to 0.20 in.) from the bottom lip of the case plug (for filler) hole.
Wait approximately 5 minutes and check that the oil level has not changed.
Install a new gasket and the case plug (for filler).
| 14. INSTALL NO. 2 ENGINE UNDER COVER |
| 15. INSTALL NO. 1 ENGINE UNDER COVER |
| 16. INSTALL TRANSFER CASE LOWER PROTECTOR |
Install the transfer case lower protector with the 4 bolts.
| 17. INSTALL TRANSFER HIGH AND LOW SHIFT LEVER ASSEMBLY |
Install the transfer shift lever.
Using pliers, install the snap ring.
| 18. INSTALL FLOOR SHIFT LEVER ASSEMBLY |
Cover the shift lever cap with a cloth.
Press down on the shift lever cap and rotate it clockwise to install it.
| 19. INSTALL SHIFT LEVER BOOT ASSEMBLY |
![]() |
Install the shift lever boot with the 4 screws and 2 clips.
| 20. INSTALL CONSOLE BOX ASSEMBLY |
| 21. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |