ENGINE > ON-VEHICLE INSPECTION |
| 1. INSPECT INJECTION TIMING |
![]() |
Using a mirror, check that the matchmarks of the injection pump flange and the timing gear case are aligned.
| 2. ADJUST INJECTION TIMING |
Loosen the following nuts and bolts.
![]() |
Bolt holding the injection pump to the injection pump stay.
2 nuts holding the injection pump to the timing gear case.
Align the matchmarks by slightly tilting the injection pump.
Tighten the following nuts and bolts.
2 nuts holding the injection pump to the timing gear case.
Bolt holding the injection pump to the injection pump stay.
| 3. INSPECT ENGINE IDLE SPEED |
Warm up the engine.
When using the intelligent tester:
Connect the intelligent tester to the DLC3.
Measure the idle speed.
When not using the intelligent tester:
![]() |
Using SST, connect the tachometer test probe to terminal 9 (TAC) of the DLC3.
Measure the idle speed.
| 4. INSPECT MAXIMUM SPEED |
Start the engine.
Fully depress the accelerator pedal.
Measure the maximum speed.
| 5. INSPECT COMPRESSION |
Warm up and stop the engine.
Remove the glow plugs (Click here).
Disconnect the spill control valve connector.
Check the cylinder compression pressure.
![]() |
Install SST (attachment) to the glow plug hole.
![]() |
Connect SST (compression gauge) to the SST (attachment).
Fully open the throttle valve, and start the engine.
While cranking the engine, measure the compression pressure.
Perform the step above for each cylinder.
Remove the SST.
Reinstall the glow plugs (Click here).
Reconnect the spill control valve connector.