OIL PUMP > REMOVAL |
| 1. REMOVE ENGINE ASSEMBLY |
Remove the engine assembly (Click here).
| 2. REMOVE TIMING BELT |
Remove the timing belt (Click here).
| 3. REMOVE INJECTION PIPE SUB-ASSEMBLY |
![]() |
Using a union nut wrench, loosen the 8 union nuts of the 4 injection pipes.
Remove the 2 nuts, 2 upper pipe clamps and 4 injection pipes together with the lower pipe clamps.
| 4. REMOVE INJECTION PUMP DRIVE PULLEY |
![]() |
Using SST, remove the pulley nut.
![]() |
Using SST, remove the drive pulley.
| 5. REMOVE INJECTION PUMP ASSEMBLY |
![]() |
Disconnect the engine speed sensor connector.
Disconnect the spill control valve connector.
Disconnect the correction unit connector.
Disconnect the timing control valve connector.
Disconnect the fuel temperature sensor connector.
Disconnect the engine wire clamp.
Disconnect the 3 fuel hoses.
![]() |
Remove the 3 bolts and injection pump stay.
Remove the 2 nuts and injection pump.
| 6. REMOVE CAMSHAFT TIMING PULLEY |
![]() |
Using SST, loosen the pulley bolt.
![]() |
Using SST, disconnect the timing pulley from the camshaft.
Remove the pulley bolt and timing pulley.
Remove the timing pulley woodruff key.
| 7. REMOVE NO. 2 TIMING BELT COVER |
Remove the 4 bolts and timing belt cover.
| 8. REMOVE WATER PUMP ASSEMBLY |
![]() |
Remove the 6 bolts and tension spring bracket.
Remove the water pump and gasket.
| 9. REMOVE NO. 1 TIMING BELT IDLER SUB-ASSEMBLY |
![]() |
Remove the 2 bolts (A and B).
Loosen the bolt (C), and remove the No. 1 timing belt idler.
| 10. REMOVE NO. 2 TIMING BELT IDLER SUB-ASSEMBLY |
Remove the bolt, No. 2 timing belt idler and spacer.
| 11. REMOVE CRANKSHAFT TIMING PULLEY |
![]() |
Using SST, remove the timing pulley.
| 12. REMOVE OIL PAN SUB-ASSEMBLY |
Remove the 16 bolts and 2 nuts.
![]() |
Insert the blade of SST between the oil pan and cylinder block, cut off the applied sealer and remove the oil pan.
| 13. REMOVE OIL STRAINER SUB-ASSEMBLY |
Remove the 2 bolts, 2 nuts, oil strainer and gasket.
| 14. REMOVE TIMING BELT CASE SUB-ASSEMBLY |
![]() |
Remove the 5 bolts, timing belt case and gasket.