ECD SYSTEM > VC Output Circuit |


| 1.CHECK MIL |
Check that the Malfunction Indicator Lamp (MIL) lights up when turning the ignition switch ON.
| Condition | Proceed to |
| MIL does not illuminate | A |
| MIL illuminates | B |
|
| ||||
| A | |
| 2.CHECK CONNECTION BETWEEN INTELLIGENT TESTER AND ECM |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and tester on.
Check the communication between the intelligent tester and ECM.
| Condition | Proceed to |
| Communication is not possible | A |
| Communication is possible | B |
|
| ||||
| A | |
| 3.CHECK MIL (THROTTLE POSITION SENSOR) |
Disconnect the throttle position sensor connector.
Turn the ignition switch to ON.
Check the MIL.
| Condition | Proceed to |
| MIL does not illuminate | A |
| MIL illuminates | B |
Reconnect the throttle position sensor connector.
|
| ||||
| A | |
| 4.CHECK MIL (MANIFOLD ABSOLUTE PRESSURE SENSOR) |
Disconnect the manifold absolute pressure sensor connector.
Turn the ignition switch to ON.
Check the MIL.
| Condition | Proceed to |
| MIL does not illuminate | A |
| MIL illuminates | B |
Reconnect the manifold absolute pressure sensor connector.
|
| ||||
| A | |
| 5.CHECK MIL (ACCELERATOR PEDAL POSITION SENSOR) |
Disconnect the accelerator pedal position sensor connector.
Turn the ignition switch to ON.
Check the MIL.
| Condition | Proceed to |
| MIL does not illuminate | A |
| MIL illuminates | B |
Reconnect the accelerator position sensor connector.
|
| ||||
| A | |
| 6.CHECK MIL (FUEL PRESSURE SENSOR) |
Disconnect the fuel pressure sensor connector.
Turn the ignition switch to ON.
Check the MIL.
| Condition | Proceed to |
| MIL does not illuminate | A |
| MIL illuminates | B |
Reconnect the fuel pressure sensor connector.
|
| ||||
| A | |
| 7.CHECK MIL (EGR VALVE POSITION SENSOR) |
Disconnect the EGR valve position sensor connector.
Turn the ignition switch to ON.
Check the MIL.
| Condition | Proceed to |
| MIL does not illuminate | A |
| MIL illuminates | B |
Reconnect the EGR valve position sensor connector.
|
| ||||
| A | |
| 8.CHECK HARNESS AND CONNECTOR (ECM - BODY GROUND) |
Disconnect the throttle position sensor connector.
Disconnect the manifold absolute pressure sensor connector.
Disconnect the fuel pressure sensor connector.
Disconnect the accelerator pedal position sensor connector.
Disconnect the EGR valve position sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E7-18 (VC) - Body ground | Always | 10 kΩ or higher |
| E6-2 (VCS) - Body ground | Always | 10 kΩ or higher |
| E4-26 (VCPA) - Body ground | Always | 10 kΩ or higher |
| E4-27 (VCP2) - Body ground | Always | 10 kΩ or higher |
Reconnect the throttle position sensor connector.
Reconnect the manifold absolute pressure sensor connector.
Reconnect the fuel pressure sensor connector.
Reconnect the accelerator pedal position sensor connector.
Reconnect the EGR valve position sensor connector.
Reconnect the ECM connector.
|
| ||||
| OK | ||
| ||