Home › SUSPENSION & AXLE › SUSPENSION › REAR COIL SPRING

REAR COIL SPRING > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL REAR COIL SPRING


F049945E01
  1. Install the coil spring and insulator to the lower control arm and frame. Fit the lower end of the coil spring into the recess of the spring lower seat.



2. TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY


C118719
  1. Support the axle housing.

    1. Jack up and support the vehicle's frame on stands.

    2. Lower the axle housing until the coil spring tension is free, and maintain this position.

  1. Remove the nut and 2 retainers.



    C118720
  1. Remove the 2 bolts.

  1. Disconnect the shock absorber and 2 bushes from the axle housing and frame.

  1. Remove the lock nut, bracket, 3 retainers and 2 cushions.



3. INSTALL REAR WHEEL

Torque:
105 N*m{ 1,071 kgf*cm , 77 ft.*lbf }



4. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Press down on the vehicle several time to stabilize the suspension.



5. FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY
  1. Tighten the bolt.

    Torque:
    82 N*m{ 816 kgf*cm , 60 ft.*lbf }



6. CONNECT REAR BRAKE TUBE FLEXIBLE HOSE
  1. Install the hose to the 3 way joint.

  1. Install the clip to the flexible hose.

  1. Connect the flexible hose to the brake line.

    Torque:
    23 N*m{ 235 kgf*cm , 20 ft.*lbf }



7. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY


8. INSTALL TAILPIPE ASSEMBLY
  1. Install the tailpipe for 1KD-FTV (Click here).

  1. Install the tailpipe for 1GR-FE (Click here).

  1. Install the tailpipe for 2TR-FE (Click here).

  1. Install the tailpipe for 5L-E (Click here).

  1. Install the tailpipe for 2KD-FTV (Click here).



9. CONNECT SKID CONTROL SENSOR WIRE


  1. Install the speed sensor with the bolt.


    C189956E01

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

    NOTICE:
    1. Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
    2. While inserting the speed sensor into the axle housing hole, do not strike or damage the sensor tip.
    3. After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the axle housing.

  1. Attach the 3 clamps.

    NOTICE:
    When attaching the clamps, do not twist the wire harness.

  1. Connect the connector.

    NOTICE:
    1. Securely connect the connector.
    2. When connecting the connector, do not twist the wire harness.

  1. Attach the connector.



10. BLEED BRAKE LINE
  1. w/ VSC:
    (Click here)

  1. w/o VSC:
    (Click here)