Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1282    Center Differential Lock Position Switch

for Preparation Click here


DESCRIPTION

DTC C1282 is stored only in Test Mode.

DTC Code
DTC Detection Condition
Trouble Area
C1282
Stored during Test Mode.
  1. Harness or connector
  2. Transfer system
  3. Skid control ECU (Brake actuator assembly)

WIRING DIAGRAM


C237081E02


INSPECTION PROCEDURE

NOTICE:
  1. After replacing the brake actuator assembly, perform calibration (Click here).
  2. Before disconnecting the connector, make sure that there are no problems with the connection.
  3. After disconnecting the connector, make sure that the connector case and terminals are not deformed or corroded.

1.CHECK TERMINAL VOLTAGE (EXI TERMINAL)
  1. Set the vehicle to the center differential lock state using the transfer shift lever.

  1. Turn the ignition switch off.



    C199357E68
  1. Disconnect the skid control ECU (brake actuator assembly) connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    S25-20 (EXI) - Body ground
    1. Ignition switch ON
    2. Transfer shift position HL
    Below 1.5 V

  1. Connect the skid control ECU (brake actuator assembly) connector.

  1. Set the vehicle to the center differential free state using the transfer shift lever.

  1. Turn the ignition switch off.

  1. Disconnect the skid control ECU (brake actuator assembly) connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    S25-20 (EXI) - Body ground
    1. Ignition switch ON
    2. Transfer shift position H
    11 to 14 V

Text in Illustration 
*a
Front view of wire harness connector
(to Skid Control ECU [Brake Actuator Assembly])


NG
Go to step 3
OK


2.CHECK TEST MODE DTC
  1. Switch the vehicle to Test Mode, check the H to LL shift operation, and then check that Test Mode DTC C1282 is cleared (Click here).
    Result 
    Result
    Proceed to
    Test Mode DTC is not cleared
    A
    Test Mode DTC is cleared
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)  

3.CHECK HARNESS AND CONNECTOR (EXI CIRCUIT)
  1. Turn the ignition switch off.

  1. Disconnect the skid control ECU (brake actuator assembly) connector.

  1. Disconnect the center differential lock position switch (No. 3 transfer indicator switch) connector.

  1. Disconnect the C28 combination meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S25-20 (EXI) - T4-2
    Always
    Below 1 Ω
    S25-20 (EXI) - Body ground
    Always
    10 kΩ or higher
    T4-1 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

GO TO TRANSFER SYSTEM (PROBLEM SYMPTOMS TABLE) (Click here)