2014 Hilux · Service Manual BODY ELECTRICAL

CD cannot be Inserted or is Ejected Right After Insertion

Circuit diagnosis · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

INSPECTION PROCEDURE

HINT:
When replacing the radio and display receiver assembly, it is necessary to perform the vehicle contract setting for T-connect.


1. CHECK IF A PROPER DISC IS INSERTED
  1. Make sure that the disc is an audio disc or a disc with an MP3, WMA or AAC file, and that it is not deformed, flawed, stained, deteriorated or otherwise defective.

    OK:
    Disc is normal.

    HINT:
    1. Translucent or uniquely-shaped CDs cannot be played.
    2. CDs and DVDs with adhesive paper labels should not be played.
    3. Commercial audio CDs and DVDs can be played.
    4. CD-DA files on CD-ROMs, CD-Rs and CD-RWs can be played.
    5. MP3, WMA and AAC files on CD-ROMs, CD-Rs and CD-RWs can be played.
    6. For details on playable CDs and DVDs, refer to Owner's Manual.



NG
CHANGE DISC
OK


2. CHECK THAT DISC IS INSERTED PROPERLY
  1. Check if the disc is inserted upside down.

    OK:
    The disc is properly inserted.



NG
INSERT DISC PROPERLY
OK


3. CHECK DISC

  1. I100151
    Disc cleaning
    1. If dirt is on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.

      OK:
      Malfunction disappears.

      NOTICE:
      Do not use a conventional record cleaner or antistatic preservative.



NG
Go to step 4
OK

END (DISC IS DIRTY)

4. REPLACE DISC WITH ANOTHER AND RECHECK
  1. Replace the disc with a known good one and check that the malfunction disappears.

    OK:
    Malfunction disappears.



NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)
OK

END (DISC IS DEFECTIVE)


← CD cannot be Inserted or is Ejected Right After Insertion (Aug 2012 – Jul 2013)CD Sound Skips (Jun 2011 – Jul 2012) →