2014 Hilux · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built Aug 2012 – Jul 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).


1. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY

  1. for LHD:

    1. Attach the 5 guides and 8 claws to install the upper instrument panel.

    2. Install the 2 bolts <A> and 2 screws <B>.

      B278236E01

      Text in Illustration 
      *A
      w/o Front Passenger Airbag
      *B
      w/ Front Passenger Airbag
      *1
      Bolt <A>
      *2
      Screw <B>

  1. for RHD:

    1. Attach the 5 guides and 8 claws to install the upper instrument panel.

    2. Install the 2 bolts <A> and 2 screws <B>.

      B278139E01

      Text in Illustration 
      *A
      w/o Front Passenger Airbag
      *B
      w/ Front Passenger Airbag
      *1
      Bolt <A>
      *2
      Screw <B>


2. INSTALL FRONT PILLAR GARNISH LH
  1. w/ Curtain Shield Airbag:

    1. Remove the protective cover.

  1. Attach the 2 guides and 2 clips to install the front pillar garnish.

  1. Install the front door opening trim.


3. INSTALL FRONT PILLAR GARNISH RH

HINT:
Use the same procedure described for the LH side.


4. INSTALL FRONT ASSIST GRIP SUB-ASSEMBLY (w/ Assist Grip)

HINT:
Use the same procedure for both front assist grips.

  1. Install the front assist grip with the 2 screws.


5. INSTALL FRONT NO. 1 ASSIST GRIP PLUG LH (w/ Assist Grip)

HINT:
Use the same procedure for both front No. 1 assist grip plugs.

  1. Attach the 2 claws to install the front No. 1 assist grip plug.


6. INSTALL FRONT NO. 1 ASSIST GRIP PLUG RH (w/ Assist Grip)

HINT:
Use the same procedure described for the LH side.


7. INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY (w/ Front Passenger Airbag)

B112264E01
  1. Attach the 12 claws to install the airbag.

  1. Attach the clamp to the bracket.

  1. B112126
    Tighten the 2 bolts.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

  1. B112127
    Connect the connector to the airbag.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.


8. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY (w/ Front Passenger Airbag)

B278068E01
  1. Attach the 2 hinges to install the glove compartment door.

    Text in Illustration 
    *1
    Hinge

  1. B278069E01
    While pushing in the sides of the glove compartment door as indicated by the arrows in the illustration, close the door to engage it to the 2 stoppers.
    Text in Illustration 
    *1
    Stopper


9. INSTALL RADIO TUNER OPENING COVER (w/o Audio)
  1. Install the radio tuner opening cover with the 4 screws.


10. INSTALL RADIO RECEIVER ASSEMBLY (w/ Audio)
  1. for Radio Receiver Type:
    (Click here)

  1. for Radio and Display Type:
    (Click here)


11. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
  1. for Manual Air Conditioning System:

    1. Connect the connectors.

    2. Attach the 4 claws to connect the air conditioner control.

    3. Attach the 10 claws and 4 clips to install the center instrument cluster finish panel.

  1. for Automatic Air Conditioning System:

    1. Connect the connectors.

    2. Attach the 8 claws and 4 clips to install the center instrument cluster finish panel.


12. INSTALL COMBINATION METER ASSEMBLY
  1. Connect the connectors and attach the clamp.

  1. Install the combination meter with the 3 screws.


13. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL
  1. Attach the 2 claws and 3 guides to install the No. 1 instrument cluster finish panel.

  1. Install the clip <C>.


14. INSTALL STEERING WHEEL ASSEMBLY
(Click here)

15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Airbag System)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


16. CHECK SRS WARNING LIGHT (w/ Airbag System)
(Click here)
← INSTALLATION (Jun 2011 – Jul 2012)INSTALLATION (from Aug 2013) →