2014 Hilux · Service Manual BRAKE

INSTALLATION

Removal / installation · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013


1. INSTALL YAW RATE SENSOR ASSEMBLY

  1. C189947E01
    Connect the connector.

    NOTICE:
    Securely connect the connector.

  1. Set the yaw rate sensor to the crossmember.

    NOTICE:
    1. Do not use any parts which have been dropped or struck.
    2. Make sure that there is no foreign matter or carpet between the bracket of the sensor and crossmember.
    3. Do not do anything to deform the bracket of the sensor, such as kicking or stepping on it.


2. INSTALL SENSOR BRACKET

  1. C189946
    Install the sensor bracket with the 2 bolts.

    Torque:
    14 N*m{ 138 kgf*cm , 10 ft.*lbf }


3. INSTALL FLOOR CARPET COVER
  1. Insert the floor carpet cover into the sensor bracket.

  1. Insert the positioning boss of the floor carpet cover into the hole in the bracket of the sensor.

  1. Attach the 4 claws to install the floor carpet cover.


4. INSTALL FRONT SEAT ASSEMBLY RH
  1. for Separate Seat:
    Install the front seat assembly RH (Click here).

  1. w/ Front Seat Side Airbag:
    Install the front seat assembly RH (Click here).

  1. for Bench Seat:
    Install the front seat assembly RH (Click here).

  1. for Power Seat:
    Install the front seat assembly RH (Click here).


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


6. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION
  1. Perform the yaw rate sensor zero point calibration (Click here).


7. CHECK YAW RATE SENSOR SIGNAL
  1. Check the yaw rate sensor signal (Click here).

← INSTALLATION (Aug 2012 – Jul 2013)COMPONENTS (from Jun 2011) →