2014 Hilux · Service Manual CRUISE CONTROL SYSTEM

FAIL-SAFE CHART

System information · Vehicles built from Jun 2011

HINT:
If the following conditions are detected while the cruise control is in operation, the system clears the stored vehicle speed in the ECM and cancels the cruise control operation.

Vehicle Condition
Auto Cancel Condition
Fail-safe Deactivation Condition
Cruise control indicator light illuminates in yellow (for 1KD-FTV [for DPF])
  1. There is an open or short in the stop light switch circuit
  2. There is a problem with the vehicle speed signal
Turn the cruise control main switch on again
  1. There is a problem with the input circuit of the stop light switch circuit
  2. There is a problem with the cancel circuit
Turn the ignition switch off and then on again
Cruise control indicator light blinks (except 1KD-FTV [for DPF])
  1. There is an open or short in the stop light switch circuit
  2. There is a problem with the vehicle speed signal
Turn the cruise control main switch on again
  1. There is a problem with the input circuit of the stop light switch circuit
  2. There is a problem with the cancel circuit
  3. There is a problem with the ECD system*1
Turn the ignition switch off and then on again
Cruise control indicator light illuminates in green
(Cruise control is canceled)
Under the following conditions, the stored vehicle speed is maintained:
  1. The vehicle speed is less than the low speed limit (approximately 40 km/h (25 mph)) while running with the cruise control on
  2. The VSC system is operated*3
Push the cruise control main switch to (+RES)
  1. The vehicle speed is less than the stored speed by approximately 16 km/h (10 mph) or more
Push the cruise control main switch to (-SET)
Cruise control indicator light goes off
There is a problem with the throttle position sensor and motor*2
Turn the cruise control main switch on again after the throttle position sensor and motor returns to normal
There is a problem with the fuel injection system*1
Fuel injection system returns to normal
  1. *1: for 1KD-FTV
  2. *2: for 1GR-FE
  3. *3: w/ VSC
← DTC CHECK / CLEAR (from Jun 2011)DATA LIST / ACTIVE TEST (from Jun 2011) →