MIL Circuit
Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
If the ECM detects a malfunction, the MIL illuminates. The ECM then records the DTC in its memory.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- If the ECM is replaced, the new ECM needs initialization (Click here).
| 1. CHECK MIL |
 |
- HINT:
- Use the table below to troubleshoot each problem symptom.
Reference:
Condition
|
Proceed to
|
MIL remains ON
|
A
|
MIL is not illuminated
|
B
|
|
B |
 |
|
|
|
| A |
|
 |
|
| 2. CHECK IF MIL TURNS OFF |
 |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the intelligent tester ON.
Enter the following menus: Powertrain / Engine / DTC.
Check if DTCs have been stored. Take notes if there are DTCs.
Enter the following menus: Powertrain / ECD / DTC / Clear.
Clear the DTC(s) (Click here).
Check if the MIL turns OFF.
- OK:
- MIL turns OFF.
|
OK |
 |
|
|
|
| NG |
|
 |
|
| 3. CHECK WIRE HARNESS |
 |
- Disconnect the E5 ECM connector.
Turn the ignition switch ON.
Check that the MIL does not illuminate.
- OK:
- MIL does not illuminate.
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS AND CONNECTOR |
|
|
| OK |
|
 |
|
|
| 4. CHECK IF MIL ILLUMINATES |
 |
Check if the MIL illuminates when the ignition switch is turned ON.
- OK:
- MIL illuminates.
|
OK |
 |
|
|
|
| NG |
|
 |
|
| 5. CHECK COMBINATION METER ASSEMBLY (MIL CIRCUIT) |
 |
- OK:
- Combination meter circuit is normal.
|
NG |
 |
|
| REPAIR OR REPLACE COMBINATION METER ASSEMBLY |
|
|
| OK |
|
 |
|
| REPAIR OR REPLACE HARNESS AND CONNECTOR (COMBINATION METER - ECM) |
|