2014 Hilux · Service Manual ENGINE

MIL Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

If the ECM detects a malfunction, the MIL illuminates. The ECM then records the DTC in its memory.

WIRING DIAGRAM

A154532E11

INSPECTION PROCEDURE

NOTICE:
If the ECM is replaced, the new ECM needs initialization (Click here).


1. CHECK MIL

HINT:
Use the table below to troubleshoot each problem symptom.

Reference: 
Condition
Proceed to
MIL remains ON
A
MIL is not illuminated
B


B
Go to step 4
A


2. CHECK IF MIL TURNS OFF
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch ON and turn the intelligent tester ON.

  1. Enter the following menus: Powertrain / Engine / DTC.

  1. Check if DTCs have been stored. Take notes if there are DTCs.

  1. Enter the following menus: Powertrain / ECD / DTC / Clear.

  1. Clear the DTC(s) (Click here).

  1. Check if the MIL turns OFF.

    OK:
    MIL turns OFF.



OK
GO TO DTC CHART (Click here)
NG


3. CHECK WIRE HARNESS

  1. A065748E09
    Disconnect the E5 ECM connector.

  1. Turn the ignition switch ON.

  1. Check that the MIL does not illuminate.

    OK:
    MIL does not illuminate.



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE ECM (Click here)

4. CHECK IF MIL ILLUMINATES
  1. Check if the MIL illuminates when the ignition switch is turned ON.

    OK:
    MIL illuminates.



OK
END
NG


5. CHECK COMBINATION METER ASSEMBLY (MIL CIRCUIT)

OK:
Combination meter circuit is normal.



NG
REPAIR OR REPLACE COMBINATION METER ASSEMBLY
OK

REPAIR OR REPLACE HARNESS AND CONNECTOR (COMBINATION METER - ECM)


← MIL Circuit (Aug 2013 – Jul 2014)COMPONENTS (from Jun 2011) →