2014 Hilux · Service Manual TRANSMISSION

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 from Aug 2012

HINT:
  1. The TCM is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
      NEXT

      3.INSPECT BATTERY VOLTAGE

        Standard voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding.
      NEXT

      4.CONNECT INTELLIGENT TESTER TO DLC3*
        NEXT

        5.CHECK AND CLEAR DTC AND FREEZE FRAME DATA*
          NEXT

          6.VISUAL INSPECTION
            NEXT

            7.SETTING CHECK MODE DIAGNOSIS*
            1. Refer to the check mode procedure (Click here).

            NEXT

            8.PROBLEM SYMPTOM CONFIRMATION
            1. Refer to the road test (Click here).

              Result:
              Result
              Proceed to
              Symptom does not occur
              A
              Symptom occurs
              B


            B.
            A

            9.SYMPTOM SIMULATION
            1. Refer to the electronic circuit inspection procedure (Click here).

            NEXT

            10.DTC CHECK*
            1. Refer to the DTC check / clear (Click here).

            2. Result:
              Result
              Proceed to
              DTC is not output
              A
              DTC is output
              B


            B.
            A

            11.BASIC INSPECTION
            1. Refer to the automatic transmission fluid (Click here).

            2. Refer to the park / neutral position switch (Click here).

            3. Refer to the floor shift assembly (Click here).


            NG.
            OK

            12.MECHANICAL SYSTEM TEST
            1. Refer to the mechanical system test (Click here).


            NG.
            OK

            13.HYDRAULIC TEST
            1. Refer to the hydraulic test (Click here).


            NG.
            OK

            14.MANUAL SHIFTING TEST
            1. Refer to the manual shifting test (Click here).


            NG.
            OK

            15.PROBLEM SYMPTOMS TABLE CHAPTER 1
            1. Refer to the problem symptoms table (Click here).


            NG.
            OK

            16.PROBLEM SYMPTOMS TABLE CHAPTER 2
            1. Refer to the problem symptoms table (Click here).


            NG.
            OK

            17.PROBLEM SYMPTOMS TABLE CHAPTER 3
            1. Refer to the problem symptoms table (Click here).

            NG

            18.PART INSPECTION

              NG.
              OK

              19.DTC CHART
              1. Refer to the diagnostic trouble code chart (Click here).

              NEXT

              20.CIRCUIT INSPECTION
                NEXT

                21.REPAIR OR REPLACE
                  NEXT

                  22.CONFIRMATION TEST
                    NEXT

                    ← SYSTEM DESCRIPTION (from Jun 2011)HOW TO PROCEED WITH TROUBLESHOOTING (from Aug 2012) →