HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Aug 2012
Versions by build date: Jun 2011 – Jul 2012 from Aug 2012
- HINT:
- The TCM is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.
- *: Use the intelligent tester.
- The TCM is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
| |||||
| 3.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
| |||||
| 4.CONNECT INTELLIGENT TESTER TO DLC3* |
| |||||
| 5.CHECK AND CLEAR DTC AND FREEZE FRAME DATA* |
| |||||
| 6.VISUAL INSPECTION |
| |||||
| 7.SETTING CHECK MODE DIAGNOSIS* |
Refer to the check mode procedure (Click here).
| |||||
| 8.PROBLEM SYMPTOM CONFIRMATION |
Refer to the road test (Click here).
- Result:
Result
Proceed to
Symptom does not occur
A
Symptom occurs
B
|
|||||
| |||||
| 9.SYMPTOM SIMULATION |
Refer to the electronic circuit inspection procedure (Click here).
| |||||
| 10.DTC CHECK* |
Refer to the DTC check / clear (Click here).
- Result:
Result
Proceed to
DTC is not output
A
DTC is output
B
|
|||||
| |||||
| 11.BASIC INSPECTION |
Refer to the park / neutral position switch (Click here).
Refer to the floor shift assembly (Click here).
|
|||||
| |||||
| 12.MECHANICAL SYSTEM TEST |
Refer to the mechanical system test (Click here).
|
|||||
| |||||
| 13.HYDRAULIC TEST |
Refer to the hydraulic test (Click here).
|
|||||
| |||||
| 14.MANUAL SHIFTING TEST |
Refer to the manual shifting test (Click here).
|
|||||
| |||||
| 15.PROBLEM SYMPTOMS TABLE CHAPTER 1 |
Refer to the problem symptoms table (Click here).
|
|||||
| |||||
| 16.PROBLEM SYMPTOMS TABLE CHAPTER 2 |
Refer to the problem symptoms table (Click here).
|
|||||
| |||||
| 17.PROBLEM SYMPTOMS TABLE CHAPTER 3 |
Refer to the problem symptoms table (Click here).
| |||||
| 18.PART INSPECTION |
|
|||||
| |||||
| 19.DTC CHART |
Refer to the diagnostic trouble code chart (Click here).
| |||||
| 20.CIRCUIT INSPECTION |
| |||||
| 21.REPAIR OR REPLACE |
| |||||
| 22.CONFIRMATION TEST |
| |||||