Connecting terminals TC and CG of the DLC3 causes the ECU to output the DTCs by blinking the ABS warning light and slip indicator light.
WIRING DIAGRAM
HINT:
When the warning light and indicator light continue to blink, there may be a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in one or more ECUs.
INSPECTION PROCEDURE
NOTICE:
After replacing the brake actuator assembly, perform calibration (Click here).
Before disconnecting the connector, make sure that there are no problems with the connection.
After disconnecting the connector, make sure that the connector case and terminals are not deformed or corroded.
1. CHECK CAN COMMUNICATION SYSTEM
Check if a CAN communication system DTC is output (Click here).
Result
Result
Proceed to
DTC is not output
A
DTC is output
B
B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A
2. INSPECT DLC3
Measure the voltage according to the value(s) in the table below.
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
Text in Illustration
*a
Front view of DLC3
Turn the ignition switch to ON.
Check that the MIL is blinking.
Result
Result
Proceed to
MIL is not blinking
A
MIL is blinking
for LHD
B
for RHD
C
HINT:
If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (Click here).
for 1KD-FTV (for DPF) and 2KD-FTV (for DPF):Disconnect the E30 ECM connector.for 1KD-FTV (except DPF) and 2KD-FTV (except DPF):Disconnect the E5 ECM connector.for 1GR-FE:Disconnect the E14 ECM connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
for 1KD-FTV (for DPF) and 2KD-FTV (for DPF)
Tester Connection
Condition
Specified Condition
D1-13 (TC) - E30-23 (TC)
Always
Below 1 Ω
D1-13 (TC) - Body ground
Always
10 kΩ or higher
for 1KD-FTV (except DPF) and 2KD-FTV (except DPF)
Tester Connection
Condition
Specified Condition
D1-13 (TC) - E5-11 (TC)
Always
Below 1 Ω
D1-13 (TC) - Body ground
Always
10 kΩ or higher
for 1GR-FE
Tester Connection
Condition
Specified Condition
D1-13 (TC) - E14-23 (TC)
Always
Below 1 Ω
D1-13 (TC) - Body ground
Always
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
5. CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
D1-4 (CG) - Body ground
Always
Below 1 Ω
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
6. CHECK ECM (DLC3 INPUT)
SST
09843-18040
Turn the ignition switch off.
Connect the ECM connector.
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.