PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built Jun 2011 – Jul 2013
Versions by build date: Jun 2011 – Jul 2013 from Aug 2013
- HINT:
- Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Proceed to the troubleshooting procedures for each circuit in the table below.
- Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
| Symptom |
Suspected Area |
See page |
| SRS warning light remains on (When ignition switch is ON, SRS warning lamp sometimes turns on after approximately 6 seconds) |
SRS warning lamp circuit |
Click here
|
| SRS warning light remains on (SRS warning lamp remains illuminated even when DTC is not output) |
SRS warning lamp circuit |
Click here
|
| SRS warning light does not come on (When ignition switch is ON, SRS warning lamp does not illuminate) |
SRS warning lamp circuit |
Click here
|
| TC and CG terminal circuit (SRS warning lamp is blinking but pattern is not DTC or normal system code) |
TC terminal circuit |
Click here
|
| TC and CG terminal circuit (Terminals TC and CG are connected but blinking pattern is not DTC or normal system code) |
TC terminal circuit |
Click here
|